 Door handle, how do you change the plastic plunger? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| arkitect |
 Dec 19 2010, 11:02 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 617 Joined: 3-March 10 From: Stockton, CA Member No.: 11,426 Region Association: None  |
Can someone give me an insight of how you change the plastic plunger? If I open the latch it comes close to releasing it, I can try to pry but afraid of breaking it.
Dave  The broken one is on the right. |
   |
 
|
  |
Replies
| SLITS |
Dec 20 2010, 08:10 AM
Post
#2
|
|
"This Utah shit is HARSH!" Group: Benefactors Posts: 13,602 Joined: 22-February 04 From: SoCal Mountains ... Member No.: 1,696 Region Association: None  |
I take the end off, pry the arms away from the body slightly, activate the mechanism as if opening the door and pull the plastic piece off.
I use a pair of channel locks to bend the arms back into place. Don't need to pry the arms away from the body a whole lot so as to avoid breaking them. |
|
|
|
Posts in this topic
arkitect Door handle Dec 19 2010, 11:02 AM
dangrouche http://www.pelicanparts.com/techarticles/9...door_... Dec 19 2010, 11:27 AM arkitect Thanks for the reply. Will try to pry it off, if t... Dec 19 2010, 11:47 AM URY914 Are you asking how to get the old one off? Just cu... Dec 19 2010, 11:52 AM McMark :agree: pry it off. If it breaks, you didn't ... Dec 19 2010, 01:22 PM arkitect Looks like I will be ordering another part from PP... Dec 19 2010, 02:31 PM URY914 PM me your address and I'll mail you one for n... Dec 19 2010, 03:42 PM
arkitect
PM me your address and I'll mail you one for ... Dec 19 2010, 04:56 PM Joe Ricard Soak the plastic part in hot water 1st.
Or get on... Dec 20 2010, 07:37 AM dr914@autoatlanta.com
I take the end off, pry the arms away from the bo... Dec 20 2010, 08:54 AM URY914 You break those arms and you are screwed. Be very ... Dec 20 2010, 02:47 PM markb
You break those arms and you are screwed. Be very... Dec 20 2010, 02:48 PM underthetire Yep, GPR, 1 day to get it. Not too hard of a job. ... Dec 20 2010, 05:11 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 09:34 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.