 Door handle, how do you change the plastic plunger? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| arkitect |
 Dec 19 2010, 11:02 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 617 Joined: 3-March 10 From: Stockton, CA Member No.: 11,426 Region Association: None  |
Can someone give me an insight of how you change the plastic plunger? If I open the latch it comes close to releasing it, I can try to pry but afraid of breaking it.
Dave  The broken one is on the right. |
   |
 
|
  |
Replies
| URY914 |
Dec 20 2010, 02:47 PM
Post
#2
|
|
I built the lightest 914 in the history of mankind. Group: Members Posts: 121,017 Joined: 3-February 03 From: Jacksonville, FL Member No.: 222 Region Association: None |
You break those arms and you are screwed. Be very careful.
|
|
|
|
Posts in this topic
arkitect Door handle Dec 19 2010, 11:02 AM
dangrouche http://www.pelicanparts.com/techarticles/9...door_... Dec 19 2010, 11:27 AM arkitect Thanks for the reply. Will try to pry it off, if t... Dec 19 2010, 11:47 AM URY914 Are you asking how to get the old one off? Just cu... Dec 19 2010, 11:52 AM McMark :agree: pry it off. If it breaks, you didn't ... Dec 19 2010, 01:22 PM arkitect Looks like I will be ordering another part from PP... Dec 19 2010, 02:31 PM URY914 PM me your address and I'll mail you one for n... Dec 19 2010, 03:42 PM
arkitect
PM me your address and I'll mail you one for ... Dec 19 2010, 04:56 PM Joe Ricard Soak the plastic part in hot water 1st.
Or get on... Dec 20 2010, 07:37 AM SLITS I take the end off, pry the arms away from the bod... Dec 20 2010, 08:10 AM dr914@autoatlanta.com
I take the end off, pry the arms away from the bo... Dec 20 2010, 08:54 AM markb
You break those arms and you are screwed. Be very... Dec 20 2010, 02:48 PM underthetire Yep, GPR, 1 day to get it. Not too hard of a job. ... Dec 20 2010, 05:11 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 7th June 2024 - 08:57 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.