![]() |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
![]() |
scotty b |
![]()
Post
#1
|
rust free you say ? ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Group: Members Posts: 16,375 Joined: 7-January 05 From: richmond, Va. Member No.: 3,419 Region Association: None ![]() |
I waited as long as I could. I dropped the wad ( well chase credit card did temporarily ) and bought the steel. Most of it I got cut to length, but there was still a fair amount I got long because I knew I would end up altering things as I went....I usually do (IMG:style_emoticons/default/dry.gif) 641.40 worth on the floor. I saved over 120.00 by digging thought the drops for 2 hours, and refiguring my original plans on the spot in order to make use of the drop pile.
Now I should probably say, before you guys think I am totally nuts, I am building this thing to handle ANY car that comes to me. I do American stuff as well, so just in case someone shows up with a '59 Cadillac coupe Deville, I nned to know I can flip it safely (IMG:style_emoticons/default/shades.gif) Started out by marking and pilot drilling the uprights for the lockdown holes, then step drilled them out to 3/4 inch Attached image(s) ![]() ![]() ![]() |
![]() ![]() |
scotty b |
![]()
Post
#2
|
rust free you say ? ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Group: Members Posts: 16,375 Joined: 7-January 05 From: richmond, Va. Member No.: 3,419 Region Association: None ![]() |
Welded the bottom legs together. Rear is 3x3 1/4 wall, front is 3x4 1/4 wall. This was the first change I made. There wasn't enough 3x3 in the drop pile but I found the 3x4. That kept me from having to buy 2 full lengths of 3x3. Cha CHING !!
Then I cut some 3x2 angle into short brakets to make a stable bolting setup in order to disassemble the whole thing for storage or moving. Drilled the tabs for bolt holes, and went back to welding (IMG:style_emoticons/default/welder.gif) Attached image(s) ![]() ![]() ![]() |
![]() ![]() |
![]() |
Lo-Fi Version | Time is now: 15th June 2024 - 02:19 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |