 Oil strainer cover nut torque |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| biker bob |
 Feb 5 2011, 12:39 PM
Post
#1
|
|
Member  Group: Members Posts: 53 Joined: 25-March 09 From: Eureks Springs Ar. Member No.: 10,200 Region Association: Southwest Region  |
What is the correct torque for the oil strainer cover nut (bolt)? It seams I remember someone saying that the Haynes book is incorrect.
|
   |
 
|
  |
Replies
| detoxcowboy |
Feb 5 2011, 02:25 PM
Post
#2
|
|
Senior Member Group: Members Posts: 1,294 Joined: 30-January 08 Member No.: 8,642 Region Association: Africa |
9.4 any more and it will cause you other problems besides just stripping it according to a 914 mechanic shop near me.. I think will start to push on some other more imporant moving part..
9.4 or 9.6 is fine and factory it is not holding back a river or all the horsepower.. |
|
|
|
Posts in this topic
biker bob Oil strainer cover nut torque Feb 5 2011, 12:39 PM
brp986s I tend to believe the 9.4 ftlb indicated in my Hay... Feb 5 2011, 01:12 PM GeorgeRud Though that seems awful low, it is correct.
VW ... Feb 5 2011, 01:48 PM vsg914 Tom Wilson book says 8. I've never had one lea... Feb 5 2011, 06:49 PM Jake Raby More isn't better. Tighten it too much and you... Feb 5 2011, 08:22 PM vsg914 If that was directed towards me, Jake, You'll ... Feb 6 2011, 06:37 AM
biker bob Thanks everyone 8 to 9 sounds good to me.
Bob Feb 6 2011, 08:25 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 7th June 2024 - 12:13 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.