Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> Carb Conversion, Replacing Distributor for Carb conversion
falconfp2001
post Feb 2 2011, 04:14 PM
Post #1


Pancho Pantera
**

Group: Members
Posts: 451
Joined: 5-December 10
From: Downey, CA
Member No.: 12,456
Region Association: Southwest Region



Quick question, for carb conversion, is the 009 Bosch the recommended Distributor?

Isn't there two versions of that Distributor?

Thanks

Frank
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
 
Reply to this topicStart new topic
Replies
VaccaRabite
post Feb 5 2011, 08:06 PM
Post #2


En Garde!
**********

Group: Admin
Posts: 13,456
Joined: 15-December 03
From: Dallastown, PA
Member No.: 1,435
Region Association: MidAtlantic Region



Replacing the cam on a t4 will do a lot for you with carbs. BUT.

Replacing the cam means that you have to split open the case. And that means a lot of work. Once the case is opened and you have the new cam, new cam bearings, etc, you may as well rebuild the entire motor. After all, its all open there. And after redoing all that work (including new pushrod geometry since you changed the cam) you may as well make sure that your heads are good, etc. etc.

Zach
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 2nd June 2024 - 10:40 AM