 rocker shims |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| TheCabinetmaker |
 Feb 20 2011, 08:54 AM
Post
#1
|
|
I drive my car everyday  Group: Members Posts: 8,339 Joined: 8-May 03 From: Tulsa, Ok. Member No.: 666  |
What is the maximum thickness of rocker shims I can use. I have the rockers shimed .050 and still can't quite get the proper alignment of the swivel adjuster.
|
   |
 
|
  |
Replies
| gothspeed |
Feb 20 2011, 12:44 PM
Post
#2
|
|
Senior Member Group: Members Posts: 1,539 Joined: 3-February 09 From: SoCal Member No.: 10,019 Region Association: None |
I decided to use stock 2.0 adjusters with lash caps on my engine. However it is my understanding, to use the swivel 911 adjuster ....... one needs to trim about .050"-.060" off the rocker bottom at the adjuster end ..... to make room for the swivel portion of the adjuster. This would allow the rocker to sit a tad lower than if not trimmed. Have you done this trim yet?
|
|
|
|
Posts in this topic
vsg914 rocker shims Feb 20 2011, 08:54 AM
vsg914 yep! Feb 20 2011, 12:59 PM
orange914 it's been awhile, but if my memory serves me r... Feb 20 2011, 05:07 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 12th July 2025 - 11:15 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.