Wiring, Fun fun fun (updated post 10) Options

[clow]

I started rewiring my car over the last couple days. Here are the latest pictures I can't figure out

The car is a 1973 1.7 with rear defrost and it had a radio. Not sure about a console or not.
Good ol' winters. I try to get it to a toasty 10C in the garage but that hardly happens with the small heater.



The tach seamed straight forward and I used this diagram
(IMG:http://www.914world.com/bbs2/uploads_offsite/forums.pelicanparts.com-12151-1299788185.1.jpg)

Here is what isn't on the diagram



Also I have 2 different seat belt safety lights. What do I use?
(IMG:http://www.914world.com/bbs2/uploads_offsite/lp1.pinkbike.org-12151-1299788185.2.jpg)
(IMG:http://www.914world.com/bbs2/uploads_offsite/lp1.pinkbike.org-12151-1299788185.3.jpg)

Where do these go? On passenger side
(IMG:http://www.914world.com/bbs2/uploads_offsite/lp1.pinkbike.org-12151-1299788185.4.jpg)

I don't think this is factory correct but I am gussing the up down is for the headlights? And that the other one unmarked could be a rear defrost?
(IMG:http://www.914world.com/bbs2/uploads_offsite/lp1.pinkbike.org-12151-1299788186.5.jpg)


I know of the underseat relay but what about the wires to the left and right of it
(IMG:http://www.914world.com/bbs2/uploads_offsite/lp1.pinkbike.org-12151-1299788186.6.jpg)


Thanks for your help!

Clow

[Dave_Darling]

(IMG:http://www.914world.com/bbs2/uploads/post-12151-1299787516_thumb.jpg)

The single empty hole is for the light that shows you when your headlight switch is pulled out one stop. Therefore "parking lights".

The second lugs on the other bulbs are likely for ground wires. Some of the instrument lights will ground through the housing; those only have one lug for the sender wire. Other lights have two lugs, and do not ground through the housing. I'm guessing those two lights are the latter type.

Where do these go? On passenger side
(IMG:http://www.914world.com/bbs2/uploads_offsite/lp1.pinkbike.org-12151-1299788185.4.jpg)

The center console wiring harness would plug into those.

I know of the underseat relay but what about the wires to the left and right of it
(IMG:http://www.914world.com/bbs2/uploads_offsite/lp1.pinkbike.org-12151-1299788186.6.jpg)

Interior light up on the back pad. Verify the wire colors against the wiring diagram, though. One of them will always be "hot", so get them out of the way when you plug your battery back in.

Oh, whoops! I just realized you weren't talking about the loose wires to the left. I'm not sure of the other two connectors in with the big bundle going to the under-seat connector. Let me think for a bit...

--DD