Targa pad, what screws hold it on? |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Targa pad, what screws hold it on? |
patssle |
Mar 12 2011, 01:53 PM
Post
#1
|
Senior Member Group: Members Posts: 981 Joined: 28-August 09 From: Houston, TX Member No.: 10,741 Region Association: None |
I've removed everything from my targa, except the front pad that fits up against the seal. I can't find the screws in the hole, there's too much "stuffing" and prodding around can't get the screwdriver in the head of the screw.
What type of screws are holding it on? Hex, flat, regular? |
AZ914 |
Mar 12 2011, 09:46 PM
Post
#2
|
914 Dumbass Group: Members Posts: 1,459 Joined: 6-January 03 From: Sunny Tucson Member No.: 98 Region Association: Southwest Region |
I just went through this. If you can pluck out some of the 'stuffing' with some small needle-nose pliers then just sting your screwdriver in until it seats. It was a pain, don't forget the vertical screws underneath the pad.
My pad was so beat up that I ended up going without. I ran perlon on the inside bottom of the targa bar and used some edging on the front. It came out pretty good! The only drawback is not the latches are exposed so you need to be sure they seat properly when using them. |
Lo-Fi Version | Time is now: 2nd June 2024 - 12:33 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |