 Inner Long Replacement in Hell Hole, Could use some advice on how to weld it to front section |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| saigon71 |
 Mar 13 2011, 06:14 PM
Post
#1
|
|
Advanced Member  Group: Members Posts: 2,000 Joined: 1-June 09 From: Dillsburg, PA Member No.: 10,428 Region Association: MidAtlantic Region 
 |
I have been following quite a few of the build threads related to this subject, but I am still a little confused about how this replacement panel gets attached at the front. Do you butt weld it with a sleeve? It looks as though it will "wrap" around the section running back from below the door...do you lap weld it and sleeve it? I left the section running back from the door a little long so I can trim it after I figure out how this thing goes together. Hopefully the attached pics help to explain the situation.
     |
   |
 
|
  |
Replies
| IronHillRestorations |
Mar 13 2011, 10:13 PM
Post
#2
|
|
I. I. R. C. Group: Members Posts: 6,731 Joined: 18-March 03 From: West TN Member No.: 439 Region Association: None
|
Yes, you butt the joints flush and everything will line up better, then put a plate on the blind side. I've also put a bulkhead inside that long, up in the suspension console area.
|
|
|
|
Posts in this topic
saigon71 Inner Long Replacement in Hell Hole Mar 13 2011, 06:14 PM
two-strokejohn Check out Jeff Hail's repairs at this http://w... Mar 13 2011, 07:32 PM
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 11th June 2024 - 02:31 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.