|
|

|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| VaccaRabite |
Aug 7 2011, 02:30 PM
Post
#1
|
|
En Garde! ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Group: Admin Posts: 13,845 Joined: 15-December 03 From: Dallastown, PA Member No.: 1,435 Region Association: MidAtlantic Region
|
Weber 40, IDF carbs. Cable throttle linkage. They are NOT synched yet, and both carbs just had rebuilding work done. I've been working very slow due to time constraints. I fired up the car Friday night!!!
But it was idling at 3000rpm. After an hour, I had the idle down to 1800 rpm. Both idle adjusters were off the stops. Using a snail, one side was drawing a 7, the other a 14. When I turned off the car, I got a backfire. My "work hour" was done, so I had to leave it at that until the next time I can work - probably next Friday. So causes for the big idle that I need to investigate:
Where can I get the good base gaskets? The ones I have are from Weber Carbs Direct and they are the ultra crappy tan cardboard. They took a set and I am sure they are leaking like a sieve. Zach |
![]() ![]() |
| SGB |
Aug 7 2011, 10:35 PM
Post
#2
|
|
just visiting ![]() ![]() ![]() ![]() Group: Members Posts: 4,086 Joined: 8-March 03 From: Huntsville, AL Member No.: 404 Region Association: South East States |
My car (40 idf, tall manifolds w/ isolators) does this if my timing is off.
Other carb issues I've experienced (besides those same plugs popping out): 1-Backfire (popping) out carbs at high rpms was ntake valves too tight. 2-Erratic idle (could be your issue if timing is right) was gummed up cam drive between the barrels that drives the accel pump caused dribbles all the time 3-Too small idle jets gave better MPG but ran hot at high RPM So, try dialing that diz back a degree. I have a mallory and when it is set up right it is almost about to run away- just a couple of degrees up and you you can tell the spark advances and RPMs climb right up to, um, about 3K... hmmm... |
Vacca Rabite Big idle Aug 7 2011, 02:30 PM
anderssj You might want to give David a call at Air Cooled ... Aug 7 2011, 03:08 PM
anderssj Just checked the Carbs Unlimited site and found th... Aug 7 2011, 03:17 PM
r_towle what "rebuilding work" did you do?
Its ... Aug 7 2011, 03:24 PM
Vacca Rabite Cleaned the jets and stacks. bored out the lead p... Aug 7 2011, 05:00 PM
jmill So causes for the big idle that I need to investig... Aug 7 2011, 05:54 PM
r_towle tighten them down at the heads and maniflod and re... Aug 7 2011, 06:42 PM
KaptKaos Are your air by pass screws all the way in? Aug 7 2011, 10:02 PM
Vacca Rabite I was about to discount the advice about checking ... Aug 8 2011, 06:02 AM
904svo Disconnect the throttle linkage, then using a flas... Aug 8 2011, 08:54 AM![]() ![]() |
|
Lo-Fi Version | Time is now: 2nd April 2026 - 12:51 PM |
| All rights reserved 914World.com © since 2002 |
|
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |