Joes 2056 build thread, Its Driving again !!!!!!!!!!!!!!!! Options

[jsayre914]

I have been searching all the 2056 threads. Their should really be a 2056 for dummies thread (IMG:style_emoticons/default/biggrin.gif)

I plan on building a 2056 D-jet from my stock 2.0 1973 motor. I have been collecting parts since 2009 (IMG:style_emoticons/default/rolleyes.gif)

Here is what I got so far:

2.0 motor (havent split it yet)
D-Jet system off my 73
4 cleaned & Tested injectors
new wiring harness from bowlsby
new tps board
new hoses
rabby 9550 cam kit
1.8 rockers and swivel feet
aa 96mm cylinder & pistons

I might be forgettin a few things, it has been a while. (IMG:style_emoticons/default/idea.gif)

The heads should be sent out within the week to be checked and prepared with new seats, valves, etc. And I will be splitting the case open this week also. All the cool kids are doing it (IMG:style_emoticons/default/smile.gif)

What other thing do I need to purchase as I begin???

gaskets, bearings, flywheel ??? (IMG:style_emoticons/default/confused24.gif)

also what tools are required other than the basic tools?

I never done this before
(IMG:style_emoticons/default/hide.gif)


thanks
Joseph

[DNHunt]

I don't know if anyone mentioned a rear main seal. They aren't in the gasket kit. I can't remember if the front seal is in there or not.

Dave

[jsayre914]

I don't know if anyone mentioned a rear main seal. They aren't in the gasket kit.
Dave

Got it ! thanks for the heads up, it was not in the kit.


More items to add to my collection:

1) Keith Black Hypereutectic Cast 2.0 2056 96mm Pistons (IMG:style_emoticons/default/drooley.gif)

2) Rear main Seal

3) Cap / Rotor / WR-7s

4) Magnecor Wire Set



sounds like my next step is to box up all my rotating pcs and send them off to Jake for balancing. And send my case off to Rimco to have it inspected and the galley plugs tapped. I will also check with local shop to measure my AA jugs for roundness. I might get the phone number of your guy Zach.

Does this sound like I am going in the right direction??

comments welcomed

(IMG:style_emoticons/default/popcorn[1].gif)