 side shift bushings, can't shift into 4th/5th |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| yorkt |
 Oct 10 2011, 03:14 PM
Post
#1
|
|
Newbie  Group: Members Posts: 3 Joined: 24-July 11 From: Ohio Member No.: 13,359 Region Association: None  |
Since I replaced the bushings in my 73 side shifter I cannot shift into 4th or 5th. What did I do wrong?
|
   |
 
|
  |
Replies
| Richard Casto |
Oct 10 2011, 03:31 PM
Post
#2
|
|
Blue Sky Motorsports, LLC Group: Members Posts: 1,465 Joined: 2-August 05 From: Durham, NC Member No.: 4,523 Region Association: South East States |
Need more details. I am assuming that once you replaced your bushings that you re-adjusted your shift linkage? I assume that 4th and 5th worked fine before? Anything else change?
In short... Select 3rd gear. Leaving the transmission in gear, loosing the pinch bolt under the shift lever. Then you position the shift lever where 3rd should be in the "H" pattern. Use the spring plate as a guide to keep it in the 2nd-3rd plane. Tighten up the pinch bolt. Verify that you can now get all six gears (1-5 and Reverse). Repeat if you don't quite get it right the first time. It's a bit more complicated than that, but that is the general idea. Richard |
|
|
|
| yorkt |
Oct 10 2011, 03:45 PM
Post
#3
|
|
Newbie Group: Members Posts: 3 Joined: 24-July 11 From: Ohio Member No.: 13,359 Region Association: None |
QUOTE(Richard Casto @ Oct 10 2011, 01:31 PM)  Need more details. I am assuming that once you replaced your bushings that you re-adjusted your shift linkage? I assume that 4th and 5th worked fine before? Anything else change? In short... Select 3rd gear. Leaving the transmission in gear, loosing the pinch bolt under the shift lever. Then you position the shift lever where 3rd should be in the "H" pattern. Use the spring plate as a guide to keep it in the 2nd-3rd plane. Tighten up the pinch bolt. Verify that you can now get all six gears (1-5 and Reverse). Repeat if you don't quite get it right the first time. It's a bit more complicated than that, but that is the general idea. Richard Thanks, Richard. Yes everything worked before we put the bushings in. Tom |
|
|
|
Posts in this topic
yorkt side shift bushings Oct 10 2011, 03:14 PM
GeorgeRud Your shifter bar is probably just indexed incorrec... Oct 10 2011, 03:25 PM
yorkt
Your shifter bar is probably just indexed incorre... Oct 10 2011, 03:43 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 09:27 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.