 Looking at a roller, What kind of work will need to be done here? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| afiniti |
 Oct 25 2011, 01:30 AM
Post
#1
|
|
Newbie  Group: Members Posts: 12 Joined: 21-October 11 From: oregon Member No.: 13,701 Region Association: Pacific Northwest  |
Hey guys, looking at a roller. Most of the car is rust free according to seller (longs, floors, etc.). There is a little surface rust here and there, but car is already stripped down on the outside. The only thing that concerns me (because I'm new at this) is this area. Can a few of you experienced guys look at these pics and tell me how much work this looks like to clean out, and if you see any major problems here? Obviously new tray and support are needed, but what about that hole down in the bottom?
(IMG:http://www.914world.com/bbs2/uploads_offsite/i1086.photobucket.com-13701-1319527843.1.jpg) (IMG:http://www.914world.com/bbs2/uploads_offsite/i1086.photobucket.com-13701-1319527843.2.jpg) (IMG:http://www.914world.com/bbs2/uploads_offsite/i1086.photobucket.com-13701-1319527843.3.jpg) |
   |
 
|
  |
Replies
| draganc |
Oct 26 2011, 09:40 AM
Post
#2
|
|
Senior Member Group: Members Posts: 725 Joined: 2-November 09 From: central new jersey Member No.: 11,000 Region Association: North East States |
Based on the battery tray pics - or what is left, I question the sellers statment "...car is rust free according to seller (longs, floors, etc.)..."
You should check as well the jack point and particular the suspnesions ears below the battery area. Can you see/check the car in person or only pics? Post your location and ask one of the club members to inspect the car with you - this will cost a few bucks or a steak and some beer. good luck! |
|
|
|
Posts in this topic
afiniti Looking at a roller Oct 25 2011, 01:30 AM
SLITS Battery support and shelf ... $80 new?
Possi... Oct 25 2011, 07:27 AM
afiniti
Battery support and shelf ... $80 new?
Poss... Oct 25 2011, 07:30 AM SLITS Battery tray assembly can be removed by drilling s... Oct 25 2011, 07:37 AM Loser_Cruiser It looks saveable, especially if you already have ... Oct 25 2011, 08:39 AM rdauenhauer I see a hole in the top of the long....
ANY penet... Oct 25 2011, 06:00 PM boogie_man That's not too bad looking. Once you remove t... Oct 26 2011, 09:21 AM SirAndy Based on the battery tray pics - or what is left, ... Oct 26 2011, 01:14 PM draganc
Based on the battery tray pics - or what is left,... Oct 26 2011, 09:31 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 01:48 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.