 Need hardware electroplated |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Harpo |
 Nov 8 2011, 07:58 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,304 Joined: 21-August 11 From: Motor City aka Detroit Member No.: 13,469 Region Association: None  |
I have some components that I would like to get cleaned up and replated in yellow zinc. Is there someone that makes regular runs to the plater?
Hood striker & latch, trunk striker & latch, engine compartment striker & latch, rear wheel hub, etc. Thanks David |
   |
 
|
  |
Replies
| PanelBilly |
Nov 14 2011, 05:33 PM
Post
#2
|
|
914 Guru Group: Members Posts: 5,882 Joined: 23-July 06 From: Kent, Wa Member No.: 6,488 Region Association: Pacific Northwest 
|
Remove the springs and send extra nuts and bolts. Use a tap and die on everything to clean out the threads
|
|
|
|
Posts in this topic
Harpo Need hardware electroplated Nov 8 2011, 07:58 PM
Tom_T I think that Eric at PMB (member vendor on here wh... Nov 8 2011, 08:28 PM McMark I send stuff to Sacramento all the time for platin... Nov 8 2011, 10:59 PM jeeperjohn56 Talk to Bruce (bdstone914) he might have some alre... Nov 9 2011, 07:23 AM Series9 I can have it done for you.
Yellow zinc
Clear zin... Nov 9 2011, 08:47 AM
Harpo Because yellow zinc & cadmium are so close in ... Nov 9 2011, 05:37 PM Series9
Because yellow zinc & cadmium are so close in... Nov 14 2011, 06:25 PM A&PGirl I make semi-regular runs to the only plater. :(
... Nov 9 2011, 02:00 PM Eric_Shea I go once or twice a week here.
Much easier to ... Nov 14 2011, 09:58 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 07:55 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.