 wrist pin clips, install and removal |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| malcolm2 |
 Dec 9 2011, 02:40 PM
Post
#1
|
|
Advanced Member  Group: Members Posts: 2,747 Joined: 31-May 11 From: Nashville Member No.: 13,139 Region Association: South East States 
 |
I plan on installing my p/c next. I noticed that the wrist pin keepers are quite different. Is there a trick to install and removal of this type of clip?? The instructions say to pull it apart. It looks like a spring, but "don't spring it". not very clear.
Thanks, Clark  |
   |
 
|
  |
Replies
| stugray |
Dec 9 2011, 02:47 PM
Post
#2
|
|
Advanced Member Group: Members Posts: 3,825 Joined: 17-September 09 From: Longmont, CO Member No.: 10,819 Region Association: None |
1 - go get a GOOD set of dental picks. Craftsman will work.
2 - To put in the new clip, you set it over the hole, then using the dental pick, get under the last "loop" of the clip in back. You should be able to push that down into the hole, then keep working your way around until it is all in there and the last bit will click in. 3 - to remove, see the little "notch" in the end of the clip ring? You would reach into the hole and grab that with the dental pick, and work it back out the reverse of how it went in. Stu |
|
|
|
Posts in this topic
malcolm2 wrist pin clips Dec 9 2011, 02:40 PM
malcolm2
1 - go get a GOOD set of dental picks. Craftsman ... Dec 9 2011, 03:20 PM
vsg914 I scratched my head at first, but its really prett... Dec 9 2011, 02:50 PM malcolm2
I scratched my head at first, but its really pret... Dec 9 2011, 03:18 PM Van Yeah, that's about how I did it when I rebuilt... Dec 10 2011, 07:01 PM Vacca Rabite I just used a set of needle nosed plyers for the s... Dec 10 2011, 11:24 PM malcolm2 Turns out it was not too difficult after all. Tha... Dec 11 2011, 09:52 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 4th June 2025 - 09:04 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.