 Buying steel, Door jam... |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| tscrihfield |
 Dec 13 2011, 08:22 PM
Post
#1
|
|
Drive Fast and Take Chances  Group: Members Posts: 643 Joined: 8-September 10 From: Amelia Ohio Member No.: 12,156 Region Association: None 
 |
Okay,
This may be a dumb question... But, does anyone sell just the bottom portion of the door jam? I just need about 4 inches from the bottom up. I don't see a need for the entire piece replaced but if I have to buy a whole one I will only use a fourth of it (IMG:style_emoticons/default/blink.gif) .... I will if I have no other option but I figure I would ask first. Thanks, Thomas |
   |
 
|
  |
Replies
| TargaToy |
Dec 13 2011, 09:20 PM
Post
#2
|
|
-NONSOLIS RADIOS SEDIOUIS FULMINA MITTO- Group: Members Posts: 714 Joined: 26-March 10 From: DelMarVa Peninsula Member No.: 11,509 Region Association: MidAtlantic Region
|
If the rounded part of that jamb is rotten, sometimes the leading edge of the rear fender (the lower pointy part) is rotten too. Check it out real good when you're making your plans to graft in the new metal.
|
|
|
|
| tscrihfield |
Dec 13 2011, 09:33 PM
Post
#3
|
|
Drive Fast and Take Chances Group: Members Posts: 643 Joined: 8-September 10 From: Amelia Ohio Member No.: 12,156 Region Association: None
|
QUOTE(TargaToy @ Dec 13 2011, 10:20 PM)  If the rounded part of that jamb is rotten, sometimes the leading edge of the rear fender (the lower pointy part) is rotten too. Check it out real good when you're making your plans to graft in the new metal. Ironically when I cut the bottom corner of the rear quarter out it was well intact. This car rusted in some of the most odd places. However, the PO had a hell of a good ol time brazing the crap out of the bottom of this door jam... (IMG:style_emoticons/default/welder.gif) Gotta love those ol' back yard fixins! Thanks for the input though... It did have me looking at it! Thomas |
|
|
|
Posts in this topic
tscrihfield Buying steel Dec 13 2011, 08:22 PM
Vysoc Hello,
Restoration Design makes the part in Left ... Dec 13 2011, 08:50 PM
tscrihfield
Hello,
Restoration Design makes the part in Left... Dec 13 2011, 09:25 PM zig-n-zag Thomas,
The factory manual shows they brazed the ... Dec 14 2011, 10:17 PM tscrihfield
Thomas,
The factory manual shows they brazed the... Dec 15 2011, 11:45 AM TargaToy The curved part of my transition was gone and the ... Dec 15 2011, 12:13 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 13th November 2025 - 10:58 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.