 Buying steel, Door jam... |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| tscrihfield |
 Dec 13 2011, 08:22 PM
Post
#1
|
|
Drive Fast and Take Chances  Group: Members Posts: 643 Joined: 8-September 10 From: Amelia Ohio Member No.: 12,156 Region Association: None 
 |
Okay,
This may be a dumb question... But, does anyone sell just the bottom portion of the door jam? I just need about 4 inches from the bottom up. I don't see a need for the entire piece replaced but if I have to buy a whole one I will only use a fourth of it (IMG:style_emoticons/default/blink.gif) .... I will if I have no other option but I figure I would ask first. Thanks, Thomas |
   |
 
|
  |
Replies
| zig-n-zag |
Dec 14 2011, 10:17 PM
Post
#2
|
|
Member Group: Members Posts: 206 Joined: 18-May 06 From: Hawaii Member No.: 6,024 |
Thomas,
The factory manual shows they brazed the bottom of the door jam to the sill, and at the seam of the sail to roof panels. Fixin mine too. |
|
|
|
| tscrihfield |
Dec 15 2011, 11:45 AM
Post
#3
|
|
Drive Fast and Take Chances Group: Members Posts: 643 Joined: 8-September 10 From: Amelia Ohio Member No.: 12,156 Region Association: None
|
QUOTE(zig-n-zag @ Dec 14 2011, 11:17 PM)  Thomas, The factory manual shows they brazed the bottom of the door jam to the sill, and at the seam of the sail to roof panels. Fixin mine too. Mine is brazed so much you can't install the seal on the door sill seam... |
|
|
|
Posts in this topic
tscrihfield Buying steel Dec 13 2011, 08:22 PM
Vysoc Hello,
Restoration Design makes the part in Left ... Dec 13 2011, 08:50 PM
tscrihfield
Hello,
Restoration Design makes the part in Left... Dec 13 2011, 09:25 PM TargaToy If the rounded part of that jamb is rotten, someti... Dec 13 2011, 09:20 PM tscrihfield
If the rounded part of that jamb is rotten, somet... Dec 13 2011, 09:33 PM TargaToy The curved part of my transition was gone and the ... Dec 15 2011, 12:13 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 11th May 2025 - 08:34 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.