 5000 mile/winter project, Worth it? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jeffdon |
 Nov 17 2011, 01:19 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,094 Joined: 24-October 06 From: oakland, ca Member No.: 7,087 Region Association: None  |
I havae about 5000 miles on my 2056 now, with no troubles other than chasing down some starting issues that were electrical in nature. Its a 2056,, webcam 494, webered motor. Stock pushrods. Runs great, but I have always thought my valve noise on the high side. My valve train geo is a bit off ideal, but about half the folks i talked to said good enough, so I left it at that.
Now that winter is coming, i am thinking I might pull the engine, and go to chromolly pushrods, and optimizing the geometry. Should not be too hard, i think i can even leave most of the tin on it. Any issues with doing this on an already broken in engine? Should I also convert to the 911 adjusters? What would ya'll do in this situation? |
   |
 
|
  |
Replies
| jeffdon |
Dec 17 2011, 10:20 AM
Post
#2
|
|
Senior Member Group: Members Posts: 1,094 Joined: 24-October 06 From: oakland, ca Member No.: 7,087 Region Association: None |
Starting to plan when I want to do this, and looking over parts. Yikes, the 911 adjusters are pricey. Coupled with the fact that I would need to source some 1.7 rockers, its not the cheapest project in the world.
So, would it be a waste of time to ONLY do the pushrods, and retain stock adjusters? What about the CB performance elephant feet? There seems to be a range of opinions on those. If I am not going to the swivel foot adjusters, should I not bother with the pushrods? |
|
|
|
Posts in this topic
jeffdon 5000 mile/winter project Nov 17 2011, 01:19 PM
clow Oh pushrods turns to valve train which turns to a ... Nov 17 2011, 02:07 PM
jeffdon
Oh pushrods turns to valve train which turns to a... Nov 17 2011, 02:40 PM r_towle yes, it is worth the effort Nov 17 2011, 02:41 PM Jake Raby We just scored a train load of 1.7 rockers and wil... Dec 17 2011, 10:28 AM jeffdon
We just scored a train load of 1.7 rockers and wi... Dec 17 2011, 04:08 PM BarberDave :trophy:
YES,YES, and YES. Get all p... Dec 17 2011, 10:46 AM Cevan I think you can assume your valvetrain geometry is... Dec 17 2011, 04:34 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 09:03 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.