 Mikey main targa seal installation problems, Has anyone run into this before? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Steve |
 Mar 18 2012, 11:54 AM
Post
#1
|
|
914 Guru  Group: Members Posts: 5,619 Joined: 14-June 03 From: Orange County, CA Member No.: 822 Region Association: Southern California 
 |
I finally got around to installing the Mikey main targa seal. Besides the issues mentioned in the included doc. 1. Having to trim chrome. 2. Having to trim roof rubber to match up.
All no big deal, but the top rubber is too long. Has anyone had this problem?  Passenger side looks ok   But the drivers side has a gap. Thanks for the help!! |
   |
 
|
  |
Replies
| Steve |
Mar 19 2012, 07:30 AM
Post
#2
|
|
914 Guru Group: Members Posts: 5,619 Joined: 14-June 03 From: Orange County, CA Member No.: 822 Region Association: Southern California
|
It's pretty obvious.. Just lay it across the top of the windshield and if it's hanging over the edge by about 3" than it needs to be returned.
|
|
|
|
Posts in this topic
Steve Mikey main targa seal installation problems Mar 18 2012, 11:54 AM
Mikey914 Yes I mistakenly cut a few too long. Drop me your ... Mar 18 2012, 12:01 PM Ian Stott Mines a little bit too long as well, it is interfe... Mar 18 2012, 05:31 PM Mikey914 I do make these about 1/2" longer than they n... Mar 18 2012, 05:36 PM jim_hoyland Could a heat gun be used to shrink the seal if it ... Mar 18 2012, 05:39 PM
Mikey914
Could a heat gun be used to shrink the seal if it... Mar 19 2012, 05:09 AM Ian Stott Could you e-mail me some suggestions/instructions ... Mar 18 2012, 06:51 PM Mikey914
Could you e-mail me some suggestions/instructions... Mar 19 2012, 05:10 AM Mr Pharmacist Mark, the seal that i emailed you about a couple o... Mar 19 2012, 06:58 AM Mikey914 Stewart you must have from the same batch. Fortuna... Mar 19 2012, 12:56 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 15th June 2024 - 11:39 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.