![]() |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
![]() |
Aaron Cox |
![]()
Post
#1
|
Professional Lawn Dart ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Group: Retired Admin Posts: 24,541 Joined: 1-February 03 From: OC Member No.: 219 Region Association: Southern California ![]() |
hey guys, what is the final hole size that is needed to be drilled for the press in wheel studs in the hub? also, what is the size of the most rear part of the stud (the size i need to spotface)
thanks guys! |
![]() ![]() |
Eric_Shea |
![]()
Post
#2
|
PMB Performance ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Group: Admin Posts: 19,279 Joined: 3-September 03 From: Salt Lake City, UT Member No.: 1,110 Region Association: Rocky Mountains ![]() ![]() |
yes... but double check that size. I was just reading through the thread again and I'm thinking it should be 14mm on all 5. Drilling through the original effectively takes all the threads off so I'm thinking 14mm is what you need not 13.
Just ran out to the garage with the calipers...14mm. Sorry for the confusion. |
![]() ![]() |
![]() |
Lo-Fi Version | Time is now: 16th June 2024 - 06:40 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |