 Tranny Bellcrank for /6 conversion..Help needed, Will this work? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| phillstek |
 May 18 2012, 06:54 AM
Post
#1
|
|
Member  Group: Members Posts: 350 Joined: 19-May 10 From: Byron Bay, Australia Member No.: 11,741 Region Association: None  |
I need to make a bellcrank and came up with this crude drawing/design. Pretty sure the bottom lever is right but not sure if the top one is.
Any of you engineer types able to critique? Will it work? Feel free to laugh at my drawing Attached thumbnail(s) 
|
   |
 
|
  |
Replies
| Dr Evil |
May 19 2012, 10:10 AM
Post
#2
|
|
Send me your transmission! Group: Members Posts: 23,002 Joined: 21-November 03 From: Loveland, OH 45140 Member No.: 1,372 Region Association: MidAtlantic Region 
|
There are some things to consider:
What is the travel of your clutch pedal? What is the travel of your throttle levers? If you can get these measurements, I can help with the design parameters for you. The /6 may have used different length throttle levers so you may have to compensate for that. Your design can do this. If you are able to change out your intermediate plate, I have several for sale with the pivot rod installed in them. However, this may be more than you want to do and there may be easier ways to get around this. I also have some pulleys that may work, but I need the measurements. |
|
|
|
Posts in this topic
phillstek Tranny Bellcrank for /6 conversion..Help needed May 18 2012, 06:54 AM
iamchappy Looks like it should work you wont need the spring... May 18 2012, 07:09 AM phillstek Thanks chappy, problem is if I had one to copy the... May 18 2012, 07:46 AM Cap'n Krusty Why not just buy one from Rich Johnson?
The Cap... May 18 2012, 08:08 AM Luke M I made one that mounts to the rear cover of a side... May 19 2012, 05:29 AM rfuerst911sc If you decide not to make one I purchased and am u... May 19 2012, 05:39 AM phillstek Thanks all,
Would like to see your pix Luke. Wen... May 19 2012, 07:15 AM Luke M Here's the pics of the bracket that I made. Yo... May 19 2012, 08:17 AM
phillstek
There are some things to consider:
What is the ... May 20 2012, 04:28 PM Dr Evil Here are designs I have poached over the years. No... May 19 2012, 10:19 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd June 2024 - 11:29 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.