 Trying to remove door fuzzy's....need ideas, Early door: Channel with fuzzy and window scraper |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Mr.242 |
 May 26 2012, 10:01 PM
Post
#1
|
|
May your glass be smaller so it's always FULL!  Group: Members Posts: 1,079 Joined: 10-June 08 From: Seattle Member No.: 9,160 Region Association: Pacific Northwest  |
I cannot for the life of me remove these aluminum channels. The screws are rusted in. I will take suggestions now...
Thanks~ Mark |
   |
 
|
  |
Replies
| OU8AVW |
May 31 2012, 05:47 PM
Post
#2
|
|
Yacht Rigger Group: Members Posts: 1,803 Joined: 1-October 08 From: Granbury, TX Member No.: 9,601 Region Association: Southwest Region |
PB Blaster is the best for rusted in parts but drilling will probably be the end result. Lubricate the bit. I use high speed steel bits, they do pretty good.
|
|
|
|
Posts in this topic
Mr.242 Trying to remove door fuzzy's....need ideas May 26 2012, 10:01 PM
993inNC Sounds like you have but one choice. Pop the head ... May 26 2012, 10:10 PM Mr.242 I'm trying....can't seem to get it done. ... May 26 2012, 10:17 PM Type 47 dup May 31 2012, 05:30 PM Type 47 After drilling out the screw heads on one door I w... May 31 2012, 05:47 PM Phoenix-MN Use a dremel tool and a cutoff wheel to cut a new ... May 31 2012, 07:05 PM Mr.242 I did the dremel tool and no luck :angry:
I di... May 31 2012, 10:55 PM
PanelBilly I picked up some great bits and they drilled right... May 31 2012, 11:46 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 8th June 2024 - 06:35 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.