 Removing stock fuel lines.., Whats the procedure for getting them out? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| speed metal army |
 Jun 17 2012, 02:40 PM
Post
#1
|
|
Waiting for the rain to stop...  Group: Members Posts: 1,068 Joined: 4-September 10 From: PNW Member No.: 12,137 Region Association: Canada  |
Tank end first?And yank em through?
|
   |
 
|
  |
Replies
| jhora |
Jun 17 2012, 03:52 PM
Post
#2
|
|
Newbie Group: Members Posts: 26 Joined: 6-March 09 From: Kentucky Member No.: 10,138 Region Association: South East States |
I just did this....
I removed them from the rear at the engine fire wall...right by the speedo cable...my engine is out there are two of those little fold over metal clips in the tunnel holding them(these are like the ones holding most elec wires in both trunks) they are accessable from the shifter adjuster lid and under the shifter area... cafefully bend them up and the lines will pull out very easy...my be a little stiff at both the front an rear firewall rubber grommets I pull both lines at the same time with out any problem... Good Luck....John |
|
|
|
Posts in this topic
speed metal army Removing stock fuel lines.. Jun 17 2012, 02:40 PM
pilothyer That's pretty much it.....push the lines throu... Jun 17 2012, 03:05 PM speed metal army Mines a late car. Dont knowif that makes any diffe... Jun 17 2012, 03:21 PM
pilothyer
Mines a late car. Dont knowif that makes any diff... Jun 17 2012, 04:42 PM speed metal army Done! It was actually easier to pull them back... Jun 17 2012, 07:06 PM jhora Jerry...you're right...sorry...mine was a 70 9... Jun 17 2012, 07:26 PM gothspeed
Done! It was actually easier to pull them bac... Jun 18 2012, 11:17 AM speed metal army
Done! It was actually easier to pull them ba... Jun 18 2012, 07:31 PM JawjaPorsche Yes, because of the angle. You don't want to ... Jun 18 2012, 11:48 AM stugray Too late, but I pulled wire through the tunnels wh... Jun 18 2012, 08:13 PM Bartlett 914 I just installed a set of SS lines. Drivers seat a... Jun 19 2012, 07:10 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th June 2024 - 01:16 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.