 Removing stock fuel lines.., Whats the procedure for getting them out? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| speed metal army |
 Jun 17 2012, 02:40 PM
Post
#1
|
|
Waiting for the rain to stop...  Group: Members Posts: 1,068 Joined: 4-September 10 From: PNW Member No.: 12,137 Region Association: Canada  |
Tank end first?And yank em through?
|
   |
 
|
  |
Replies
| Bartlett 914 |
Jun 19 2012, 07:10 AM
Post
#2
|
|
Advanced Member Group: Members Posts: 2,216 Joined: 30-August 05 From: South Elgin IL Member No.: 4,707 Region Association: Upper MidWest |
I just installed a set of SS lines. Drivers seat and center console is out. This gave me easy access to the plate on the top of the tunnel in front. There you can see the lines going into the rubber plug into the front. I pulled the lines out there and pushed the plug into the tank area. Old lines were easy to get out ans I pushed the new ones in easily. Used a little soap to lubricate the rubber for the tubes and to make it easier to push back in place.
|
|
|
|
Posts in this topic
speed metal army Removing stock fuel lines.. Jun 17 2012, 02:40 PM
pilothyer That's pretty much it.....push the lines throu... Jun 17 2012, 03:05 PM speed metal army Mines a late car. Dont knowif that makes any diffe... Jun 17 2012, 03:21 PM
pilothyer
Mines a late car. Dont knowif that makes any diff... Jun 17 2012, 04:42 PM jhora I just did this....
I removed them from the rear ... Jun 17 2012, 03:52 PM speed metal army Done! It was actually easier to pull them back... Jun 17 2012, 07:06 PM jhora Jerry...you're right...sorry...mine was a 70 9... Jun 17 2012, 07:26 PM gothspeed
Done! It was actually easier to pull them bac... Jun 18 2012, 11:17 AM speed metal army
Done! It was actually easier to pull them ba... Jun 18 2012, 07:31 PM JawjaPorsche Yes, because of the angle. You don't want to ... Jun 18 2012, 11:48 AM stugray Too late, but I pulled wire through the tunnels wh... Jun 18 2012, 08:13 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 05:27 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.