 Powering a light with two different sources of 12 Volt power, one doesn't affect the other |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Tom |
 Sep 22 2012, 01:48 PM
Post
#1
|
|
Advanced Member  Group: Members Posts: 2,139 Joined: 21-August 05 From: Port Orchard, WA 98367 Member No.: 4,626 Region Association: None  |
Possible by using two steering diodes. I believe 1N4001 diodes will support 1 amp. Should be more than enough for a small indicator lamp.
Jim, one power from relay ( black/yellow), other from fan. Tom Attached thumbnail(s) 
|
   |
 
|
  |
Replies
| tradisrad |
Sep 22 2012, 05:08 PM
Post
#2
|
|
Senior Member Group: Members Posts: 985 Joined: 11-September 06 From: San Mateo, CA Member No.: 6,815 Region Association: Northern California |
If the EGR indicator is nonfunctional disconnect its wire from the dash and attach your fan wire.
I installed an LED into my oil temp gauge to indicate when my fan is on.  |
|
|
|
Posts in this topic
Tom Powering a light with two different sources of 12 Volt power Sep 22 2012, 01:48 PM
jim_hoyland I am attempting to use some of the CAT wiring to t... Sep 22 2012, 03:47 PM
jim_hoyland
If the EGR indicator is nonfunctional disconnect ... Sep 22 2012, 05:52 PM Cap'n Krusty Had me baffled for a moment, then I decided you me... Sep 22 2012, 05:09 PM tradisrad I bought the LED at Frys Electronics. I was sure t... Sep 22 2012, 09:06 PM kg6dxn
Possible by using two steering diodes. I believe ... Sep 22 2012, 09:11 PM Tom Mike,
Yes, two different power sources to li... Sep 23 2012, 02:02 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 03:43 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.