 tail shifter rear linkage, 4s vs 6s |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| porbmw |
 Oct 22 2012, 02:06 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 817 Joined: 10-September 08 From: Vancouver, B.C. Member No.: 9,534 Region Association: None 
 |
Are the tail shifter rear linkage covers the same for both 4s and 6s....Don't know WHY they would differ, but then.....
IF so, any sources out there for a clean unmolested one...(and if they different, any soucrecs for one going to a 6? Thanks Paul |
   |
 
|
  |
Replies
| GeorgeRud |
Oct 23 2012, 04:13 PM
Post
#2
|
|
Advanced Member Group: Members Posts: 3,725 Joined: 27-July 05 From: Chicagoland Member No.: 4,482 Region Association: Upper MidWest |
I have factory heat exchangers on both of my cars ( one a 914 side shifter, and the other a vellios 915), and there were no interference problems on either.
|
|
|
|
Posts in this topic
porbmw tail shifter rear linkage Oct 22 2012, 02:06 PM
gms
Are the tail shifter rear linkage covers the same... Oct 22 2012, 02:08 PM
porbmw
Are the tail shifter rear linkage covers the sam... Oct 22 2012, 05:58 PM toolguy The six cover is taller, no way to make a 4 fit on... Oct 22 2012, 06:31 PM GeorgeRud Actually, I can't think of any reason to not s... Oct 23 2012, 11:38 AM rudedude Does the side shift linkage interfere in any way w... Oct 23 2012, 12:03 PM gms
Does the side shift linkage interfere in any way ... Oct 25 2012, 08:09 AM porbmw
Does the side shift linkage interfere in any way... Oct 25 2012, 11:15 AM brant on my 6 with headers and a side shift....
the shi... Oct 25 2012, 11:41 AM porbmw
on my 6 with headers and a side shift....
the sh... Oct 25 2012, 04:50 PM Eric_Shea Paul, use the side shift and get a used sideshift ... Oct 25 2012, 07:24 PM porbmw
Paul, use the side shift and get a used sideshift... Oct 25 2012, 10:39 PM Eric_Shea Here's where I ran into issues...
It's no... Oct 26 2012, 01:39 PM brant Here is ours... a straight-hollow-cromoly bar with... Oct 26 2012, 02:39 PM Dr Evil I probably have a /6 cone if you are interested. Oct 26 2012, 06:18 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 4th November 2025 - 01:28 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.