 Tranny Leak, Sideshifter type |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| bcheney |
 Dec 31 2012, 07:14 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,341 Joined: 16-November 03 From: Orlando, FL Member No.: 1,348 Region Association: South East States  |
I was having look around under my recently completed 6 conversion this a.m. and was inspecting shift rod set screws for tightness. When I took off the rear cover this is what I found...gear oil came out and made this puddle...What is the source of this in your best estimation??
Attached image(s)  
|
   |
 
|
  |
Replies
| Dr Evil |
Jan 1 2013, 09:25 PM
Post
#2
|
|
Send me your transmission! Group: Members Posts: 23,002 Joined: 21-November 03 From: Loveland, OH 45140 Member No.: 1,372 Region Association: MidAtlantic Region 
|
Dont forget new O-ring around the outside of the console.
1- Remove fill plug (so you know you can refill it. 2- Drain tranz. 3- Remove shift rod set screws. 4 - Set tranz in neutral (you can move the shifter in/out with no resistance when in neutral) 5- Remove 2 x 13mm nuts that hold the console to the tranz. 6 - Remove the console and watch for some more oil. To replace the seal in the console, you drive out the roll pin from the INSIDE comb and then pull the rod out. Remove the seal, replace, slide the rod back in, put comb on and roll pin it. Then, put a new O-ring on the outside of the console, make sure the sealing surface in the trans is clean in the bore, stick it all back together. (IMG:style_emoticons/default/thumb3d.gif) |
|
|
|
Posts in this topic
bcheney Tranny Leak Dec 31 2012, 07:14 AM
jimkelly see this = posts #111 onward
http://www.914world.... Dec 31 2012, 08:32 AM
bcheney
see this = posts #111 onward
http://www.914world... Dec 31 2012, 10:02 AM mrholland2 It is very "doable" even if you are in a... Dec 31 2012, 10:36 AM 914itis I did this last month. Easy fix! No more than ... Dec 31 2012, 09:04 AM Cap'n Krusty And don't be the guy who puts the comb on the ... Jan 1 2013, 10:45 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th June 2024 - 04:50 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.