 brake issue, 914/6 conversion |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| alcantera |
 Jan 3 2013, 07:43 PM
Post
#1
|
|
Newbie  Group: Members Posts: 7 Joined: 19-December 12 From: Heidelberg ontario Member No.: 15,268 Region Association: None  |
My conversion ran into a little snag today. I could not install my rebuilt calipers with the backing plates installed . When i removed the backing plates the calipers would bolt on ,but when i tightened the bolts the caliper rubs the rotor . im wondering if the wrong calipers came back from the rebuilder, do i need to shim out the rotor??? . Strange I thought this would be a ten minute job .
  |
   |
 
|
  |
Replies
| Jeff Hail |
Jan 3 2013, 09:18 PM
Post
#2
|
|
Senior Member Group: Members Posts: 1,141 Joined: 3-May 07 From: LA/ CA Member No.: 7,712 |
You didnt by chance replace bearings and seals did you? There is a spacer ring and o-ring that goes behind the inner bearing on 911 stuff. If its not in there the rotor and hub will be to far in. The grease cap kind of hints at that issue.
Attached image(s) 
|
|
|
|
Posts in this topic
alcantera brake issue Jan 3 2013, 07:43 PM
jimkelly are you talking about the dust shields??
if so, y... Jan 3 2013, 07:45 PM John What combination of parts do you have there?
On 9... Jan 3 2013, 08:16 PM wndsnd I put my front shields on backwards.And had same r... Jan 3 2013, 08:58 PM alcantera Thanks for the prompt reply.,I can clearly see a d... Jan 3 2013, 09:12 PM alcantera i think my problem is I have early hubs not sc hu... Jan 3 2013, 10:10 PM Eric_Shea 7mm spacers between the caliper1/2s = 20mm rotor. ... Jan 3 2013, 10:18 PM Eric_Shea Hubs "shouldn't" be a big deal. Tho... Jan 3 2013, 10:21 PM alcantera
Hubs "shouldn't" be a big deal. Th... Jan 6 2013, 09:28 AM
alcantera Everything fits perfectly, Thanks again guys Jan 6 2013, 09:33 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 11:18 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.