 19mm Brake Master Cylinder, Sources? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Spoke |
 Jan 7 2013, 01:39 PM
Post
#1
|
|
Jerry  Group: Members Posts: 7,193 Joined: 29-October 04 From: Allentown, PA Member No.: 3,031 Region Association: None 
 |
I'm looking for a 19mm brake master cylinder.
I've seen them on Stoddard and PP for >$250. I ran across the (seemingly) same MC for a lot less. What's the deal with these lower priced MCs? Part number is 911 355 012 02 Autoparts Warehouse: MC for $77.32 Amazon: MC for $69.07 Ebay: MC for $92.75 Stoddard: MC for $308 |
   |
 
|
  |
Replies
| SLITS |
Jan 7 2013, 02:08 PM
Post
#2
|
|
"This Utah shit is HARSH!" Group: Benefactors Posts: 13,602 Joined: 22-February 04 From: SoCal Mountains ... Member No.: 1,696 Region Association: None  |
URO is Chinese. Their warehouse was out of Camarillo, CA. I used two of them though I have heard some others had a bad experience with them.
When I bought them (some time ago), the only complaint I had was the feed line rubbers and lack of washers underneath them. I used the old rubbers and washers off the old ATE. Haven't had any problems in 3 years. Maybe I am just lucky. |
|
|
|
Posts in this topic
Spoke 19mm Brake Master Cylinder Jan 7 2013, 01:39 PM
scotty b dont forget this jackoff
http://www.pmbperforman... Jan 7 2013, 01:44 PM
SirAndy They're cheap aftermarket copies. The higher p... Jan 7 2013, 01:54 PM Mikey914 Not to say that aftermarket is bad, but take a loo... Jan 7 2013, 01:55 PM porsche913b_sp Sorry for slight de-rail of topic. How can you tel... Jan 7 2013, 02:31 PM SLITS
Sorry for slight de-rail of topic. How can you te... Jan 7 2013, 02:52 PM Tom_T IMHO stick with ATE & get them from Eric/PMB o... Jan 7 2013, 03:06 PM Cap'n Krusty Seems to me GPR had 'em on special a week or 2... Jan 7 2013, 03:54 PM Eric_Shea I'm not a hater but... I'm still sticking ... Jan 7 2013, 06:22 PM bigkensteele
I'm not a hater but... I'm still sticking... Jan 7 2013, 11:23 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 16th July 2025 - 03:39 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.