 Engine Recipe?, Reliable, high torque motor |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Tigre81 |
 Feb 11 2013, 08:04 PM
Post
#1
|
|
paul@mnr  Group: Members Posts: 17 Joined: 19-February 08 From: MidOhio Member No.: 8,727 Region Association: Upper MidWest  |
Hi,
I just pulled the 1.7 out of the 70 i've been putting new floors in. I had planned to run it for a while. This is not gonna happen. I've never had an engine that was moldy internally. The crank is seized, the cam is seized. Im sure it was full of water at some point. Anyway, I'd like to put together a dependable motor that is more in the 7.5 seconds 0 -60 MPH range. I have multiple 1.7 engines and a 1.8 engine sitting around. I'd rather just build a good motor now than trust another unknown bottom end. Djet, Ljet or carbs are fine. So, with that; anyone care to share a good build list/recipe for such a beast? Thanks, Paul |
   |
 
|
  |
Replies
| 02loftsmoor |
Feb 12 2013, 08:11 PM
Post
#2
|
|
Senior Member Group: Members Posts: 577 Joined: 26-June 11 From: Ft. Worth TX Member No.: 13,243 Region Association: Southwest Region 
|
lots of $$$$$$$$
|
|
|
|
Posts in this topic
Tigre81 Engine Recipe? Feb 11 2013, 08:04 PM
7275914911
Hi,
I just pulled the 1.7 out of the 70 i'v... Feb 11 2013, 08:59 PM SirAndy Since you have multiple cores, i'd go with a 2... Feb 12 2013, 08:29 PM
jdlmodelt
Since you have multiple cores, i'd go with a ... Feb 12 2013, 08:44 PM euro911
Since you have multiple cores, i'd go with a... Feb 13 2013, 12:40 AM Tigre81 Thanks everyone! I read through the recommend... Feb 13 2013, 08:40 PM GeorgeRud The cheapest alternative may be an LS engine swap.... Feb 12 2013, 08:48 PM Vacca Rabite For a 2056 you need the crank out of a 2.0.
It... Feb 13 2013, 09:01 PM euro911 Joe O'Brien (Series9) is selling a 2L std/std ... Feb 13 2013, 11:57 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st August 2025 - 07:06 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.