 new cap screws for mirror |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| siverson |
 Feb 14 2013, 12:22 AM
Post
#1
|
|
Advanced Member  Group: Benefactors Posts: 2,448 Joined: 5-May 03 From: San Diego, CA Member No.: 654 Region Association: Southern California 
 |
Yes, my car is still in a million pieces, but I had to order some other hardware and these always bothered me. Even when new I seem to mangle them with the wrong screwdriver.
http://www.mcmaster.com/#catalog/119/3103/=lgxhms Ok, maybe I should get the suspension and drive train back in now... -Steve Attached image(s)    
|
   |
 
|
  |
Replies
| jersey914 |
Feb 16 2013, 08:37 AM
Post
#2
|
|
Member Group: Members Posts: 161 Joined: 6-September 12 From: Marlton, NJ Member No.: 14,895 Region Association: North East States |
Did you drill out to hit those thread locations or were the holes already there? The PO over 74' filled them in with weld so I cant drill out from the inside. the bit just rolls of the weld. It also piratically impossible to drill what you cant see.
(IMG:style_emoticons/default/WTF.gif) |
|
|
|
Posts in this topic
siverson new cap screws for mirror Feb 14 2013, 12:22 AM
Chris H. Thanks for the info! Those look great. Never... Feb 14 2013, 09:34 AM JmuRiz That's nice, I have two good ones and two mang... Feb 14 2013, 10:21 AM siverson M6 x 12. This one:
http://www.mcmaster.com/#cadin... Feb 14 2013, 10:07 PM johnpierre So cool that you have sorted that out. My screws a... Feb 16 2013, 01:48 AM dlkawashima There should be threaded holes inside the door ski... Feb 16 2013, 02:40 AM rfuerst911sc Did you alter the finish on the mirror base ? I th... Feb 16 2013, 05:51 AM siverson > But the way when I go to replace the screw wi... Feb 17 2013, 12:26 PM dlkawashima To find the correct location to drill the holes fo... Feb 17 2013, 05:06 PM
Drums66 Bump :wavebye: Mar 3 2013, 04:55 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 04:20 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.