![]() |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
![]() |
malcolm2 |
![]()
Post
#1
|
Advanced Member ![]() ![]() ![]() ![]() Group: Members Posts: 2,747 Joined: 31-May 11 From: Nashville Member No.: 13,139 Region Association: South East States ![]() ![]() |
I am sure this has happened because of my A.D.D. This car needs so much work, I have been jumping around from area to area and I had no need to remove the left front wheel during my renovation until this week. (IMG:style_emoticons/default/WTF.gif)
I can only get two of the 4 bolts loose. The master cylinder is out of the car so I have no brakes to help hold the wheel. I have an impact wrench that has helped get 2 off, but these last two are really on there. I have a 4 foot pipe on my wrench and there is just not enough weight on the tire. The tire just spins. If I could come up with a way to lock the wheel I might be ok. Otherwise, I am using propane to heat the head of the bolt and Blaster and other sprays break them loosen. I spray and leave it during the day. Then after work I have been putting the torch on the head of the bolt and holding it for 3 to 5 minutes. I let it cool down and try the impact wrench. Spray, work on something else and then try again. Anyone had any other ideas? (IMG:style_emoticons/default/headbang.gif) (IMG:style_emoticons/default/headbang.gif) |
![]() ![]() |
luskesq |
![]()
Post
#2
|
Member ![]() ![]() Group: Members Posts: 276 Joined: 24-October 10 From: Fresno, CA Member No.: 12,303 Region Association: Central California ![]() |
If you are trying to keep the wheel from spinning, put the two loosened ones back in, leaving them to protrude out from the wheel. Hopefully they will be out far enough for you to wedge a pipe, crowbar or something similar that between the two loosened lugs leaving the long end to wedge against the floor when turning. (clear as mud?) You can then perhaps use a cheater bar on your lug wench/or my preference deep socket (3/4" fits I believe) and breaker bar.
Good luck. Keith |
jersey914 |
![]()
Post
#3
|
Member ![]() ![]() Group: Members Posts: 161 Joined: 6-September 12 From: Marlton, NJ Member No.: 14,895 Region Association: North East States ![]() |
If you are trying to keep the wheel from spinning, put the two loosened ones back in, leaving them to protrude out from the wheel. Hopefully they will be out far enough for you to wedge a pipe, crowbar or something similar that between the two loosened lugs leaving the long end to wedge against the floor when turning. (clear as mud?) You can then perhaps use a cheater bar on your lug wench/or my preference deep socket (3/4" fits I believe) and breaker bar. Good luck. Keith (IMG:style_emoticons/default/agree.gif) |
![]() ![]() |
![]() |
Lo-Fi Version | Time is now: 16th June 2024 - 06:31 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |