Starter problems, not disengaging Options

[florida 914]

I have a 76 x19 2.0 with starter issues. The starter does not disengage unless the key is completely off (the intermediate, accessories position does not work -- it's either starting, or nothing). On the advice of the other forum, I tried pulling the yellow wire off once started, and it runs fine then. Supposedly that meant it was the ignition switch, but when I replaced it the problem persisted. So then I was told the starter solenoid was bad, so I replaced the starter. Still the same. I then tried a second new switch in the hopes that the first one was merely defective, but it's still the same issue.

Any ideas?

Thanks!

[florida 914]

Oops: "x19" is a typo. I meant x19.

I have a 76 x19 2.0 with starter issues. The starter does not disengage unless the key is completely off (the intermediate, accessories position does not work -- it's either starting, or nothing). On the advice of the other forum, I tried pulling the yellow wire off once started, and it runs fine then. Supposedly that meant it was the ignition switch, but when I replaced it the problem persisted. So then I was told the starter solenoid was bad, so I replaced the starter. Still the same. I then tried a second new switch in the hopes that the first one was merely defective, but it's still the same issue.

Any ideas?

Thanks!

[AE354803]

Since you replaced the ignition switch and no help and the starter with no help, I would suspect that a wire is installed incorrectly on the ignition switch and is giving juice to the START circuit when in the RUN position.

I'm guessing you reinstalled the ignition switch wires on the same pins that they were on before?

Try disconnecting the Yellow wire from the ignition switch after you put it to run, if that stops the starter then either both switches are bad or you are on the wrong pin. If not, I would start checking out the relay board

How/when/what was done to the car right before this happened?

I would take the ignition switch out, hook a wire from battery directly to the "battery in" wire on the ignition switch and figure out which pins are hot on which key positions just to make sure.

[florida 914]

Is it possible to plug in the ignition switch incorrectly? I can only find one way for it to go. Also, this problem just started one day without me having changed anything.

Since you replaced the ignition switch and no help and the starter with no help, I would suspect that a wire is installed incorrectly on the ignition switch and is giving juice to the START circuit when in the RUN position.

I'm guessing you reinstalled the ignition switch wires on the same pins that they were on before?

Try disconnecting the Yellow wire from the ignition switch after you put it to run, if that stops the starter then either both switches are bad or you are on the wrong pin. If not, I would start checking out the relay board

How/when/what was done to the car right before this happened?

I would take the ignition switch out, hook a wire from battery directly to the "battery in" wire on the ignition switch and figure out which pins are hot on which key positions just to make sure.