![]() |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
![]() |
worn |
![]()
Post
#1
|
can't remember ![]() ![]() ![]() ![]() Group: Members Posts: 3,164 Joined: 3-June 11 From: Madison, WI Member No.: 13,152 Region Association: Upper MidWest ![]() ![]() |
In a few threads I have asked for and received advice. Here is the outcome:
![]() Engine built from 1.7 to 2056. Tranny completely rebuilt. New synchs, new bearings, new seals. ARP rod bolts, a webcam, 8.4:1 compression. I am adding a direct gauge in addition to the vdo at the dash. AFM and CHT will go with them. But, I am taking the 911 down Route 66. I am leaving in a couple of weeks and don't have time to get the new engine swapped into the teener. I am driving from Madison WI as far as Albuquerque NM. Then back through the western rockies. Any suggestions? Also, a collection of shops might come in handy. Thanks everyone. Especially parts suppliers such as Valy and Rhody Guy. I have photos of the whole thing, so if anyone is interested I could make a thread. |
![]() ![]() |
TheCabinetmaker |
![]()
Post
#2
|
I drive my car everyday ![]() ![]() ![]() ![]() ![]() Group: Members Posts: 8,304 Joined: 8-May 03 From: Tulsa, Ok. Member No.: 666 ![]() |
Stop and visit me in tulsa. My shop is 1 mile off route 66. I'll buy you some lunch (or dinner or breakfast as the case may be) I'd put you up for the night but just don't have the room in my small house.
|
![]() ![]() |
![]() |
Lo-Fi Version | Time is now: 9th June 2024 - 12:31 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |