 6 engine question, Cam choice with T engine |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jmill |
 Apr 9 2013, 07:54 PM
Post
#1
|
|
Green Hornet  Group: Members Posts: 2,449 Joined: 9-May 08 From: Racine, Wisconsin Member No.: 9,038 Region Association: Upper MidWest  |
So I have a 2.2 T and 2.4 T engine. I can't come up with the cash for new S spec P&Cs right now. The short term plan was to use the 2.2 case (2.4 case needs more work) and the 2.4 crank, rods, P&Cs and whichever heads looked the best. Am I stuck with the T cams or can I get some more power with different cams?
|
   |
 
|
  |
Replies
| 914Sixer |
Apr 9 2013, 08:34 PM
Post
#2
|
|
914 Guru Group: Members Posts: 8,912 Joined: 17-January 05 From: San Angelo Texas Member No.: 3,457 Region Association: Southwest Region 
|
I always liked E cams the best. Good low and mid range power for all around driving. If you go back and read the articles from the 70's R&T recommended the 911E over the S.
|
|
|
|
Posts in this topic
jmill 6 engine question Apr 9 2013, 07:54 PM
JmuRiz Are you using carbs or mfi?
If it's a 2.4T wit... Apr 9 2013, 08:52 PM scotty b Solex or E cams. S cams are nothing but top end. T... Apr 9 2013, 09:02 PM jmill I only have T P&C's. Can they handle the ... Apr 9 2013, 09:22 PM scotty b I THINK you wil be o.k., but you should probably c... Apr 9 2013, 10:15 PM Cap'n Krusty IME, and I confirmed this with Walt Watson at Comp... Apr 9 2013, 10:16 PM
Mark Henry
IME, and I confirmed this with Walt Watson at Com... Apr 10 2013, 07:16 AM brant The problem is going to mostly be the piston clear... Apr 9 2013, 10:52 PM Cap'n Krusty Better make up your mind pretty fast. There's... Apr 10 2013, 07:39 PM jmill Thanks for the replies guys and the offer Capt... Apr 12 2013, 08:13 PM toolguy T pistons with an E cam need and additional .040 c... Apr 12 2013, 09:26 PM rick 918-S Good choice. I think unless your really ready to g... Apr 12 2013, 09:29 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 17th June 2024 - 09:44 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.