Pictures from weekend @ Willow Springs, too hot - questions... |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Pictures from weekend @ Willow Springs, too hot - questions... |
siverson |
Jul 12 2004, 04:00 PM
Post
#1
|
Advanced Member Group: Benefactors Posts: 2,448 Joined: 5-May 03 From: San Diego, CA Member No.: 654 Region Association: Southern California |
I spent the weekend at the NASA event at Willow Springs. It was pretty fun, and a very fast track - 125 on front stretch, about 105 or so on the back stretch. Turn 8/9 right at about 90/100 mph. Yowzers. I had never driven on that fast of corners before.
It think it was about 105 degrees out too, and my car started to get too hot in the afternoon sessions. I actually had to stop the 20 minute run sessions early. I was quite surprised by this, as I had previously been concerned that the car is running too cool on the freeways. Hmmm... I'm running a 3.6 with a front mounted Mocal cooler that's 20x6x2 or so. Another 914 there had a 4.0 (from a 3.6) with the factory C2 cooler under the rear trunk AND a front mounted cooler that was 16x6x2 or so. I think my DME programming might still be a little off (too lean) contributing to the heat. I'll have to check it out. Does anyone have any real world experience with the GT engine lids? Do they really make a cooling difference? Anything else to consider besides fuel/timing and engine lid before I start cutting away for a second cooler somewhere? -Steve Attached image(s) |
campbellcj |
Jul 14 2004, 11:13 PM
Post
#2
|
I can't Re Member Group: Members Posts: 4,549 Joined: 26-December 02 From: Agoura, CA Member No.: 21 Region Association: Southern California |
Here's a few (kinda lame) pics of my cooler setup. Note that the shrouding at the front spans all the way between the headlight buckets, and then tapers back to the width of the cooler itself. The taper is nearly 10" IIRC so I figure this gives a bit of "ram" effect. Also I don't have a pic with the top shroud piece removed, but as mentioned before the cooler is laid-back at approx 45 ° angle. The entire trunk floor section behind and under the cooler (back side) is cut out and flared slightly.
Attached image(s) |
Lo-Fi Version | Time is now: 10th June 2024 - 02:47 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |