 Oil tank/ cooler plumbing help |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| chad newton |
 Aug 6 2013, 11:41 PM
Post
#1
|
|
Member  Group: Members Posts: 110 Joined: 26-August 11 From: behind the red curtain Member No.: 13,491 Region Association: None  |
Ok, I am going to end up with my tank in the back in the battery box position and run a regular cooler in the front. I have no idea how to plumb it. Can I run aluminum hard line or should I go with some type of hose? Where do you run your cooler from, oil tank or engine? Is there any pressure in this system at all? Even a good link would be awesome that I could do my research on. Thanks again.
|
   |
 
|
  |
Replies
| brant |
Aug 7 2013, 03:56 PM
Post
#2
|
|
914 Wizard Group: Members Posts: 11,640 Joined: 30-December 02 From: Colorado Member No.: 47 Region Association: Rocky Mountains 
|
I have partial aluminum lines on my old retired race car. It's a pain in the butt to install the lines and they like to seep at the joints. When we built the current race car it wasn't worth trying it again.
|
 |
|
Posts in this topic
chad newton Oil tank/ cooler plumbing help Aug 6 2013, 11:41 PM
chad newton Oh, line size would also be helpful for the whole ... Aug 6 2013, 11:42 PM naro914 do you plan to use your heater? Aug 7 2013, 05:39 AM
chad newton
do you plan to use your heater?
No way, just bri... Aug 7 2013, 09:29 AM Mark Henry AN-12 (3/4" ID)
Engine sump to external therm... Aug 7 2013, 09:25 AM chad newton
AN-12 (3/4" ID)
Engine sump to external ther... Aug 7 2013, 09:46 AM chad newton Dose anyone have a picture or discription of the e... Aug 7 2013, 10:09 AM chad newton Is a thermostat mandatory with these engines? Aug 7 2013, 10:29 AM stugray thermostats can save you from blowing out a cooler... Aug 7 2013, 10:49 AM chad newton Dose anyone see a problem with running aluminum ha... Aug 7 2013, 01:40 PM stugray
I was considering running it from the rear remot... Aug 7 2013, 02:14 PM stugray brant,
What type of fitting did you install at t... Aug 7 2013, 04:46 PM brant I ran under the rocker but outside the long bat th... Aug 7 2013, 06:54 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 10th June 2024 - 08:27 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.