 Shift knob removal, Aftermarket knob won't come off |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| NFBrown |
 Aug 15 2013, 10:44 AM
Post
#1
|
|
Newbie  Group: Members Posts: 34 Joined: 27-February 13 From: Boise, Idaho Member No.: 15,587 Region Association: Pacific Northwest  |
I just got a dandy new stock shift knob but I can't get the beat-up leather covered one off. Of couse I don't know how it's attached (just bought the car) but assuming it used a stock crush washer should it just pull off? I probably should get a new crush washer before I cut the knob off (IMG:style_emoticons/default/dry.gif)
Always wanted a 914, finally got one. Please help the newbe. Nick |
   |
 
|
  |
Replies
| VaccaRabite |
Aug 15 2013, 03:33 PM
Post
#2
|
|
En Garde! Group: Admin Posts: 13,729 Joined: 15-December 03 From: Dallastown, PA Member No.: 1,435 Region Association: MidAtlantic Region 
|
Agree with everyone else.
Check for the set screw! That is a really common way to attach aftermarket knobs. |
 |
|
Posts in this topic
NFBrown Shift knob removal Aug 15 2013, 10:44 AM
76-914 My guess is that it was glued on because the PO di... Aug 15 2013, 11:12 AM stugray To start with, I would put a crescent or open end ... Aug 15 2013, 11:22 AM Eric_Shea
:agree:
You would have to heat the shaft to 500... Aug 15 2013, 11:23 AM Rob-O Post a pic of the leather covered one. Many had s... Aug 15 2013, 11:57 AM luskesq Before you go hammering on stuff, make sure there ... Aug 15 2013, 11:59 AM rick 918-S I have one that has a threaded collar at the base ... Aug 15 2013, 03:11 PM r_towle just use a sawzall and shorten the shaft...its too... Aug 15 2013, 04:38 PM NFBrown It "was" glued on. It's in pieces n... Aug 15 2013, 06:01 PM
Vacca Rabite You can use paper or felt (better) instead of a cr... Aug 15 2013, 06:08 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 02:00 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.