 What hardware to connect clutch cable to throw out lever arm? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| shuie |
 Sep 2 2013, 05:57 PM
Post
#1
|
|
Member  Group: Members Posts: 352 Joined: 17-May 04 From: baton rouge, la Member No.: 2,075  |
I need to post a WTB for a couple of random small parts so I can get my clutch cable connected to the throwout bearing lever. I know I need the threaded bracket that attaches the cable to the lever. I also know I need the M10 bolt and a washer to secure the wheel/guide that the cable rides on. Is there anything else, any other brackets, etc, not shown in the pic below that I need? I cannot tell exactly what I need from PET and I just want to make sure I ask for the right stuff.
TIA (IMG:http://www.914world.com/bbs2/uploads_offsite/lh6.googleusercontent.com-2075-1378166219.1.JPG) |
   |
 
|
  |
Replies
| euro911 |
Sep 3 2013, 02:41 PM
Post
#2
|
|
Retired & living the dream. God help me if I wake up! Group: Members Posts: 8,886 Joined: 2-December 06 From: So.Cal. & No.AZ (USA) Member No.: 7,300 Region Association: Southern California 
|
I don't think the PET diagram shows this, but in some applications, a spacer may be needed between the trunnion block and the two nuts (as mentioned earlier). This is even with brand new cables on two of my cars (IMG:style_emoticons/default/confused24.gif)
I run the cable as follows: Through the arm - trunnion block - flat washer - 1.25" spacer - flat washer - nut 1 & nut 2. |
|
|
|
Posts in this topic
shuie What hardware to connect clutch cable to throw out lever arm? Sep 2 2013, 05:57 PM
Harpo You need one of these and two jam nuts.
They are ... Sep 2 2013, 06:55 PM shuie Yeah, I just looked in PET again and the clevis ha... Sep 2 2013, 07:03 PM euro911 Try to locate a metal trunnion block, not the plas... Sep 2 2013, 07:09 PM bandjoey You also need the tab washer that locks the cable ... Sep 2 2013, 07:11 PM shuie Does anyone have a picture of all of this stuff in... Sep 2 2013, 08:23 PM turk22 Here's a Pic from Bob's thread, and a coup... Sep 2 2013, 09:22 PM stugray part #:
911-423-205-03-M260
At pelican.
Stu Sep 2 2013, 10:29 PM Harpo Any one know the P/N of that special washer in the... Sep 3 2013, 05:57 AM
shuie yep, 914-423-283-00-OEM. They had (2) when I order... Sep 3 2013, 06:45 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 10th May 2025 - 01:32 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.