MS guru's! What MS for a /6 turbo?, researching and deciding on a system, bit OT, it's for a 930 Options

[Mark Henry]

Researching a FI system for a buddies late model 930, not much more than a low mile stock 3.4 engine with cams and a bit beefier snail.

I have another bud with a totally gonzo 930 with SDS, that car is a rocket (450+hp, extreme heads, paulter rods...etc.) and the SDS runs flawless on it, so SDS is in the running......But this guy has a clewette/electomotive crankfire (missing tooth) dual plug coilpack system already, so MS is a definite candidate as well.

So what would be the best system that uses (ties into) the existing ignition?
I can solder or would a finished system (like MS3 pro) be better?

I know many of you have gone this route so I'm hoping to pick some brains. (IMG:style_emoticons/default/smile.gif)

[Mark Henry]

So what I'm reading is the build time on an ECU is about a day?


So before I start making up a list is this all I need for the MS3 ECU?

http://www.diyautotune.com/catalog/megasqu...case-p-419.html

It describing this as a "daughter board" so is there also a "mother board" I need to buy?
This confusion of too many options is one of the only things that's kept me away from MS

I see the expander board as well and I know there's a list of other bits needed, that's not what I'm talking about right now.
Just the complete ECU then I'll post a complete other parts list.

Thanks

[rick 918-S]

So what I'm reading is the build time on an ECU is about a day?


So before I start making up a list is this all I need for the ECU?

http://www.diyautotune.com/catalog/megasqu...case-p-419.html

It describing this as a "daughter board" so is there also a "mother board" I need to buy?
This confusion of too many options is one of the only things that's kept me away from MS

I see the expander board as well and I know there's a list of other bits needed, that's not what I'm talking about right now.
Just the complete ECU then I'll post a complete other parts list.

Thanks

Same deal for me. I've been to the MS web site a number of times and started to read all the stuff. By the time I was 5 minutes in I was staring at my computer like a deer in the headlights trying to figure out what I was supposed to build or buy.... (IMG:style_emoticons/default/wacko.gif)

Someone should do a post with like what they purchased, how much it cost and how much time it took to build it or is there s generic ready built one out there. I want to run ITB's that I am building manifolds for.