 2.7 crank and rods question |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Peashooter |
 Dec 11 2013, 12:12 PM
Post
#1
|
|
Member  Group: Members Posts: 165 Joined: 17-December 11 From: SW Ohio Member No.: 13,903 Region Association: None  |
The crankshaft and rods for a 2.7 engine I have are apart and since I don't have any notes with it, I don't know which rod went on which journal. Assuming new bearings, does it matter?
|
   |
 
|
  |
Replies
| SLITS |
Dec 11 2013, 03:09 PM
Post
#2
|
|
"This Utah shit is HARSH!" Group: Benefactors Posts: 13,602 Joined: 22-February 04 From: SoCal Mountains ... Member No.: 1,696 Region Association: None  |
As I remember, they are not offset in any manner to be number 1 through 6 positions. It would be highly important that the rod cap is mated to the rod it came off of ... there should be numbers or markings on the side of the end of the beam and cap that match.
|
|
|
|
Posts in this topic
Peashooter 2.7 crank and rods question Dec 11 2013, 12:12 PM
gothspeed The way I recall if they are not yet precision bal... Dec 11 2013, 04:58 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 14th July 2025 - 04:12 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.