 2.7 crank and rods question |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Peashooter |
 Dec 11 2013, 12:12 PM
Post
#1
|
|
Member  Group: Members Posts: 165 Joined: 17-December 11 From: SW Ohio Member No.: 13,903 Region Association: None  |
The crankshaft and rods for a 2.7 engine I have are apart and since I don't have any notes with it, I don't know which rod went on which journal. Assuming new bearings, does it matter?
|
   |
 
|
  |
Replies
| gothspeed |
Dec 11 2013, 04:58 PM
Post
#2
|
|
Senior Member Group: Members Posts: 1,539 Joined: 3-February 09 From: SoCal Member No.: 10,019 Region Association: None |
The way I recall if they are not yet precision balanced. You can weigh each of them, then put them into pairs, lightest to heaviest pairs. Installing the heaviest pair opposite each other starting at the flywheel. then the next lightest pair opposite each other, then the lightest pair.
You can even put the heavy one of the next pair to offset the weight of the lightest one of the previous pair. this works fairly well and can get you within a 'balanced spec' if planned well. Especially if you coordinate with the heavy parts of an unbalanced crank and flywheel ..... (IMG:style_emoticons/default/smile.gif) Of course this does not work for parts that have never been used (new) and are way off, but can work for parts already in the 'ball park'. |
|
|
|
Posts in this topic
Peashooter 2.7 crank and rods question Dec 11 2013, 12:12 PM
SLITS As I remember, they are not offset in any manner t... Dec 11 2013, 03:09 PM
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 14th July 2025 - 04:14 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.