 Tarret Sway Bar install, Argh.... |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jrrhdmust |
 Jan 15 2014, 11:09 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,408 Joined: 12-October 11 From: Alabama Member No.: 13,668 Region Association: None  |
So I decided i would start drilling the holes for my Tarret front sway bar. I had downloaded the instructions from Pelican parts read through them a few times. I cut out the template and marked my holes. I drilled the bottom hole, and got the bright idea, that I would put bolts in the Tarret backing plate to verify and check my holes.
Much to my surprise my hole was wrong....then it dawned on me the Pelican parts instructions were for a stock sway bar...mine was Tarrett... (IMG:style_emoticons/default/headbang.gif) So now my 2 minute hole is going to cost me about 4 hours of welding and grinding to build a tiny plate to weld the hole shut.... (IMG:style_emoticons/default/headbang.gif) And all i had to do was match the template to the part and save me all of the trouble..... (IMG:style_emoticons/default/blink.gif) |
   |
 
|
  |
Replies
| Eric_Shea |
Jan 16 2014, 04:03 PM
Post
#2
|
|
PMB Performance Group: Admin Posts: 19,304 Joined: 3-September 03 From: Salt Lake City, UT Member No.: 1,110 Region Association: Rocky Mountains  |
I don't think I'd worry about it, when you weld in the backing plate you can cover the hole and weld the extra then.
P.S. Why didn't you just use the backing plate as the template? |
|
|
|
Posts in this topic
jrrhdmust Tarret Sway Bar install Jan 15 2014, 11:09 AM
Harpo I also have the Tarret sway bar and I also used th... Jan 15 2014, 06:32 PM jrrhdmust The template from pelican is larger - like a 1/2 i... Jan 16 2014, 08:54 AM jpnovak Bummer. Sounds like your template did not print t... Jan 16 2014, 01:46 PM jrrhdmust Ding ding ding we have a winner, the template didn... Jan 17 2014, 12:11 PM
SirAndy Ding ding ding we have a winner, the template didn... Jan 17 2014, 01:05 PM r_towle where to start...
Your first mistake was reading ... Jan 17 2014, 03:32 PM Socalandy
So I decided i would start drilling the holes for... Jan 17 2014, 10:57 PM sixnotfour drop it down another 1/4 to insure no rubbing on g... Jan 17 2014, 11:22 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 03:28 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.