 Eliminating Heat Exchangers |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Bulldog9 |
 Feb 18 2014, 08:41 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 705 Joined: 21-August 13 From: United States Member No.: 16,283 Region Association: MidAtlantic Region  |
The rust monster destroyed my heat exchangers, and for this initial build I will be going without them. I'm exploring some alternative heat options (in #770 update) and have made some headway, but for now I will be going without exchangers, and need to figure out what to do with the normal outlets in the shroud that connect to the exchangers and then cabin.
What is the best way to deal with the air outlets in the fan shroud? I could Fill with JB weld, but not a good idea if I ever decide to or if I stumble on a set of exchangers (unlikely) but dont want to just leave open......... found these, too bad they will not work http://www.ebay.com/itm/like/130830510710?lpid=82 |
   |
 
|
  |
Replies
| bdstone914 |
Feb 18 2014, 09:03 PM
Post
#2
|
|
bdstone914 Group: Members Posts: 4,531 Joined: 8-November 03 From: Riverside CA Member No.: 1,319 |
I would use silicone rubber to attach the flappers on the fan shroud to the shroud. If you do not have them cut some out of thin aluminum. The would not be too hard to scrape off if you do go to heat later.
|
|
|
|
Posts in this topic
Steve Pratel Eliminating Heat Exchangers Feb 18 2014, 08:41 PM
SirAndy
I would use silicone rubber to attach the flapper... Feb 18 2014, 10:07 PM jcd914 If I remember correctly (always a big if) I have r... Feb 18 2014, 11:34 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 01:34 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.