 Going to Drop the Engine |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| PlantMan |
 Jun 3 2014, 06:21 PM
Post
#1
|
|
Member  Group: Members Posts: 438 Joined: 14-May 14 From: Mission Viejo Member No.: 17,352 Region Association: Southern California  |
Hey all!!!
I appreciate everyone's input on these forums.... I wish the Internet was around the last time I owned a 914. Anyways, after I get some road testing done on my recent purchase I am going to pull the engine in order to begin the 'hell hole' rust work. The question is, how high should I get the car in the air to slide the motor out the ass end??? I would assume that having the car dropped somewhat towards the front would be helpful in providing more clearance at the back. Again, appreciate all the help!!! |
   |
 
|
  |
Replies
| AfricanHijinx |
Jun 3 2014, 06:32 PM
Post
#2
|
|
Member Group: Members Posts: 132 Joined: 12-April 11 From: Snohomish WA Member No.: 12,928 Region Association: Pacific Northwest |
I was just a low rider jack stand to drop the motor and I used my custom ramps that I made out of wood which are about 13 inches tall. I still had to remove the air cleaners and barely got the motor out.
hope that helps you out |
|
|
|
Posts in this topic
PlantMan Going to Drop the Engine Jun 3 2014, 06:21 PM
toolguy front wheels on the ground, jackstands under the r... Jun 3 2014, 06:32 PM AfricanHijinx these are my ramps I just used some extra 2x8s tha... Jun 3 2014, 07:11 PM Dave_Darling About 3" higher than your jack stands will go... Jun 3 2014, 08:20 PM
PlantMan
About 3" higher than your jack stands will g... Jun 3 2014, 11:12 PM larss I just found this neat little lift which makes lif... Jun 3 2014, 11:10 PM PlantMan
I just found this neat little lift which makes li... Jun 3 2014, 11:16 PM larss
Nice!
Is that a hydraulic hand pump that ra... Jun 3 2014, 11:21 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 8th June 2024 - 06:26 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.