 targa moulding removal, removal tools and techniques |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| dangrouche |
 Jun 7 2014, 03:34 PM
Post
#1
|
|
dangrouche  Group: Members Posts: 550 Joined: 1-May 04 From: San Francisco Bay Area Member No.: 2,012 Region Association: None  |
I am going to replace the butyl on the rear glass; does the plastic rectangular surrounds (where the targa top mates into the rectangular hole) need to be removed prior to anything else, or does the targa trim come off with the surrounds attached?
Attached thumbnail(s) 
|
   |
 
|
  |
Replies
| pete000 |
Jun 7 2014, 11:33 PM
Post
#2
|
|
Senior Member Group: Members Posts: 1,885 Joined: 23-August 10 From: Bradenton Florida Member No.: 12,094 Region Association: South East States |
Just went through this on my car. Replaced the rear window. The pad is removed first. Then the latches. Near impossible to do the latches first. The pad is held in place with a bunch of sheet metal screws.
|
|
|
|
Posts in this topic
dangrouche targa moulding removal Jun 7 2014, 03:34 PM
bdstone914 This come out with the pad. Removing and replacing... Jun 7 2014, 05:30 PM
dangrouche
This come out with the pad. Removing and replacin... Jun 7 2014, 05:39 PM Mblizzard Pretty sure it has to come out to remove the glass... Jun 7 2014, 05:57 PM orthobiz Top pad removal is really hard. Some of the screws... Jun 7 2014, 06:39 PM dangrouche Paul, you are right, I think I have the two secret... Jun 7 2014, 07:48 PM bdstone914 You do not have to remove the targa latches to rem... Jun 7 2014, 07:57 PM dangrouche
You do not have to remove the targa latches to re... Jun 7 2014, 08:32 PM jmalone
You do not have to remove the targa latches to re... Jun 7 2014, 09:57 PM ChrisNPDrider Don't loose patience! :beer2:
Once I hel... Jun 8 2014, 11:55 AM PanelBilly The first time I removed mine, I had to drill out ... Jun 8 2014, 01:59 PM Dave_Darling I seem to recall a couple of rather small screws i... Jun 8 2014, 10:33 PM ruby914
I seem to recall a couple of rather small screws ... Jun 9 2014, 09:54 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 07:35 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.