 targa moulding removal, removal tools and techniques |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| dangrouche |
 Jun 7 2014, 03:34 PM
Post
#1
|
|
dangrouche  Group: Members Posts: 550 Joined: 1-May 04 From: San Francisco Bay Area Member No.: 2,012 Region Association: None  |
I am going to replace the butyl on the rear glass; does the plastic rectangular surrounds (where the targa top mates into the rectangular hole) need to be removed prior to anything else, or does the targa trim come off with the surrounds attached?
Attached thumbnail(s) 
|
   |
 
|
  |
Replies
| Dave_Darling |
Jun 8 2014, 10:33 PM
Post
#2
|
|
914 Idiot Group: Members Posts: 14,991 Joined: 9-January 03 From: Silicon Valley / Kailua-Kona Member No.: 121 Region Association: Northern California 
|
I seem to recall a couple of rather small screws in the area of the latch? They were gone on my car, but I've seen them on a couple of other cars, like Jenny's old car when we stripped it.
--DD |
|
|
|
Posts in this topic
dangrouche targa moulding removal Jun 7 2014, 03:34 PM
bdstone914 This come out with the pad. Removing and replacing... Jun 7 2014, 05:30 PM
dangrouche
This come out with the pad. Removing and replacin... Jun 7 2014, 05:39 PM Mblizzard Pretty sure it has to come out to remove the glass... Jun 7 2014, 05:57 PM orthobiz Top pad removal is really hard. Some of the screws... Jun 7 2014, 06:39 PM dangrouche Paul, you are right, I think I have the two secret... Jun 7 2014, 07:48 PM bdstone914 You do not have to remove the targa latches to rem... Jun 7 2014, 07:57 PM dangrouche
You do not have to remove the targa latches to re... Jun 7 2014, 08:32 PM jmalone
You do not have to remove the targa latches to re... Jun 7 2014, 09:57 PM pete000 Just went through this on my car. Replaced the rea... Jun 7 2014, 11:33 PM ChrisNPDrider Don't loose patience! :beer2:
Once I hel... Jun 8 2014, 11:55 AM PanelBilly The first time I removed mine, I had to drill out ... Jun 8 2014, 01:59 PM ruby914
I seem to recall a couple of rather small screws ... Jun 9 2014, 09:54 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th June 2024 - 01:07 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.