 Dellorto Carbs, How to sync and get the most out of them. |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| kixx |
 Jul 28 2014, 11:31 AM
Post
#1
|
|
Newbie  Group: Members Posts: 11 Joined: 6-July 11 From: AR Member No.: 13,283 Region Association: None  |
Hello All, I have worked on carbs before but have never had to sync them, I have looked on here and have not found the sync ing carbs for dummies guide yet. I am at a loss on where to find info for the dell carbs to get started. The car does start and run as well as idles fair, really seems to just bottom out (lacks power) when i try to get it up to speed. Any and all help is very much appreciated, also i will be needing a temp sensor and a set of air filters for them, any good shop references ??? Thanks, Best Regards
|
   |
 
|
  |
Replies
| rhodyguy |
Aug 6 2014, 04:13 PM
Post
#2
|
|
Chimp Sanctuary NW. Check it out. Group: Members Posts: 22,084 Joined: 2-March 03 From: Orion's Bell. The BELL! Member No.: 378 Region Association: Galt's Gulch |
that is a facet pump. they are not regulated. is there a fuel pressure regulator in-between the pump and the the carbs? first things i would do are replace the pump with a self regulated one (you'll barely hear it) and replace the fuel lines from the tunnel lines out. i know this prob not what you want to hear but it makes things right from the start. sorry.
kevin |
|
|
|
| kixx |
Aug 7 2014, 08:48 PM
Post
#3
|
|
Newbie Group: Members Posts: 11 Joined: 6-July 11 From: AR Member No.: 13,283 Region Association: None |
QUOTE(rhodyguy @ Aug 6 2014, 05:13 PM)  that is a facet pump. they are not regulated. is there a fuel pressure regulator in-between the pump and the the carbs? first things i would do are replace the pump with a self regulated one (you'll barely hear it) and replace the fuel lines from the tunnel lines out. i know this prob not what you want to hear but it makes things right from the start. sorry. kevin I have not seen a regulator, ? on the tunnel lines out not sure what you are talking about.. I can look to see what fuel pump my 75 has with those webber carbs, a chance that it would be the correct one? |
|
|
|
Posts in this topic
kixx Dellorto Carbs Jul 28 2014, 11:31 AM
ConeDodger I would start with the linkage. The common hex bar... Jul 28 2014, 12:31 PM yeahmag CB Performance makes a guide that will walk you th... Jul 28 2014, 05:44 PM PotterPorsche Start here:
http://www.aircooled.net/vw-carbureto... Jul 28 2014, 07:59 PM kixx Thank you all very much, I will post specific on t... Aug 5 2014, 03:11 PM anderssj PM sent. Aug 5 2014, 05:07 PM rhodyguy first thing i want to know is what sort of fuel pu... Aug 5 2014, 05:20 PM Eric_Shea This site is also good:
www.performanceoriented.c... Aug 5 2014, 05:24 PM kixx These are on the 71 (the one i am going with unles... Aug 6 2014, 02:18 PM kixx Fuel pump Aug 6 2014, 02:19 PM rhodyguy where's the pump picture? you need to ditch th... Aug 6 2014, 02:27 PM
kixx
where's the pump picture? you need to ditch t... Aug 6 2014, 02:49 PM yeahmag Looks like you may have a vacuum port uncapped too... Aug 6 2014, 02:32 PM kixx
Looks like you may have a vacuum port uncapped to... Aug 6 2014, 02:45 PM kixx this is how i got the car, i have not done much, m... Aug 6 2014, 02:44 PM yeahmag You may want to sell those. I ran 45's on a fu... Aug 6 2014, 02:47 PM kixx
You may want to sell those. I ran 45's on a f... Aug 6 2014, 02:51 PM ThePaintedMan Good spot Aaron. They should both have a vacuum ni... Aug 6 2014, 02:51 PM kixx
Good spot Aaron. They should both have a vacuum n... Aug 6 2014, 02:56 PM yeahmag Single barrels aren't going to help you much. ... Aug 6 2014, 03:00 PM kixx
Single barrels aren't going to help you much.... Aug 6 2014, 03:08 PM yeahmag Just buy the CB rotary pump. Good regulators cost ... Aug 7 2014, 08:56 PM ThePaintedMan
Just buy the CB rotary pump. Good regulators cost... Aug 8 2014, 07:07 AM rhodyguy I was down Portland way and went to a aircooled pa... Aug 8 2014, 07:16 AM ThePaintedMan
I was down Portland way and went to a aircooled p... Aug 8 2014, 07:41 AM damesandhotrods
I was down Portland way and went to a aircooled p... Aug 8 2014, 09:46 AM rhodyguy Discount Import Parts in Milwaukie Aug 8 2014, 09:52 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 03:57 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.