 Por 15 |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| partwerks |
 Sep 24 2014, 08:24 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,593 Joined: 7-September 06 From: Grand Island, NE Member No.: 6,787  |
What would be the best combo to use on the floor pans, once the floor tar is off? I have solid pans, so only anticipating surface rust.
http://www.amazon.com/POR-15-45008-Gloss-b...#productDetails For the center tunnel, or can/should the tunnel be taken off to remove the rust? http://detaildoctor.com/internal-frame-coa...-wspray-nozzle/ |
   |
 
|
  |
Replies
| OllieG |
Sep 25 2014, 02:40 AM
Post
#2
|
|
OllieG Group: Members Posts: 212 Joined: 6-July 11 From: UK Member No.: 13,282 Region Association: England |
QUOTE(partwerks @ Sep 25 2014, 03:24 AM)  What would be the best combo to use on the floor pans, once the floor tar is off? I have solid pans, so only anticipating surface rust. http://www.amazon.com/POR-15-45008-Gloss-b...#productDetails For the center tunnel, or can/should the tunnel be taken off to remove the rust? http://detaildoctor.com/internal-frame-coa...-wspray-nozzle/ I've never used POR15 tbh…read about it and it looks like a lot of steps and procedures..it also seems to have mixed reviews. I have great results with simple 2-part epoxy primer. The stuff is bomb proof and non-porous. Not sure what the best way to treat 'hard to reach' surface rust in the centre-tunnel or Longs is. For the tub I'm restoring I'm probably just going to use a rust encapsulator, then either epoxy prime and/or cavity wax it. |
|
|
|
Posts in this topic
partwerks Por 15 Sep 24 2014, 08:24 PM
jacksun for the center tunnel I used a shop vac at one end... Sep 25 2014, 05:41 AM wndsnd It is holding up well with my restoration. I used... Sep 25 2014, 10:10 AM dan_the _body_guy the key to por15 is its supposed to be applied dir... Sep 25 2014, 11:25 AM
SirAndy the key to por15 is its supposed to be applied dir... Sep 25 2014, 05:21 PM rjames
the key to por15 is its supposed to be applied di... Sep 25 2014, 11:15 PM barefoot I've had good luck with Loctite "Extend... Sep 25 2014, 04:07 PM partwerks Until the tar is off, I guess I won't ultimate... Sep 25 2014, 08:16 PM BeatNavy :agree: I've used it on four applications (tw... Sep 26 2014, 04:49 AM BeatNavy Just to give more detail on my experience:
1. Use... Sep 26 2014, 07:07 AM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd June 2024 - 08:59 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.