 Tail shifter leak, so I fixed it. |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| eyesright |
 Oct 29 2014, 06:22 PM
Post
#1
|
|
Member  Group: Members Posts: 430 Joined: 8-January 12 From: OK Member No.: 13,979 Region Association: Southwest Region  |
I bought this -6 conversion project on Ebay too many years ago. It finally got off jackstands and I filled the transmission with GL-5. The next morning I found a good sized puddle under the shift rod. It wasn't the first "au krappe" moment for this project.
 So I drained the oil. I would like to have saved it but it was getting too complicated...  |
   |
 
|
  |
Replies
| Dr Evil |
Nov 5 2014, 08:22 AM
Post
#2
|
|
Send me your transmission! Group: Members Posts: 23,038 Joined: 21-November 03 From: Loveland, OH 45140 Member No.: 1,372 Region Association: MidAtlantic Region 
|
Nope, that bolt is new to me, but a nice mod.
You can put the trans in gear and it will give you a shot at the roll pin without having to take off the tail cone. Remove the shift rod and you can rotate the internal rod a little more. That seal was nashtay. Excellent write up with picks, too bad everyone doesnt have that hole/bolt. |
|
|
|
Posts in this topic
eyesright Tail shifter leak Oct 29 2014, 06:22 PM
eyesright Pull the bolt and tap the roll pin with a punch.
... Oct 29 2014, 06:26 PM eyesright So I can either lower the transmission or loosen t... Oct 29 2014, 06:32 PM eyesright Tap in the seal...
Slide the rod back in...
Oct 29 2014, 06:45 PM eyesright Tap the roll pin back in...
The view from below... Oct 29 2014, 06:48 PM eyesright A DAPO is one who can't use a paper gasket but... Oct 29 2014, 06:55 PM eyesright I tightened up the header and added fresh GL-5. Re... Oct 29 2014, 07:01 PM JawjaPorsche Great Job! Pictures really help. :beer2: Oct 29 2014, 08:12 PM cpavlenko That just looked to simple, great job. :beer2: als... Oct 29 2014, 08:19 PM Cap'n Krusty An admin needs to move this to the classic threads... Oct 29 2014, 08:56 PM
Kansas 914
An admin needs to move this to the classic thread... Oct 30 2014, 10:19 AM zipedadoo Wish I had seen this before I did mine.........I ... Oct 30 2014, 01:27 PM eyesright
Wish I had seen this before I did mine.........I... Nov 2 2014, 05:49 PM boxsterfan But were you able to get the header back on? :pop... Oct 30 2014, 02:04 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 04:30 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.